Kenwood KDC-BT858U, Instruction Manual

Page: 58 / 100

58
|
KDC-X998/ KDC-BT958HD/ KDC-X898/ KDC-BT858U
13. Display settings
13-1. Selecting a display type
Shown below are examples of display types.
1
Press [Control] knob.
Enters the Function setting mode.
2
Select “DISP&ILLUMI” > “Display Select” >
“Type Select” using [Control] knob.
For how to use [Control] knob, refer to <3-3. How
to select the item> (page 13) .
3
Select a Display type using [Control] knob.
Display type Display information
Type A Displays 3 lines of text.
Type B Displays 2 line of text.
Type C Displays the clock.
Type D Displays the Spectrum analysis
[1]
/Motion graphics
[2]
.
Type E Turn off the display and key illumination. (5 seconds
after completion of operation)
[1] Function of KDC-X998/ KDC-BT958HD.
[2] Function of KDC-X898/ KDC-BT858U.
Exiting from the Function setting mode
Press and hold [
1
/
6
].
13-2. Information display setting
You can set the side and graphic parts of the
display.
1
Press [Control] knob.
Enters the Function setting mode.
2
Select “DISP&ILLUMI” > “Display Select” using
[Control] knob.
For how to use [Control] knob, refer to <3-3. How
to select the item> (page 13) .
3
Select a display setting item using [Control]
knob.
Display Description
“Type Select” Selects the display type.
Refer to <13-1. Selecting a display type>
(page 58) .
“Side Select” Sets the side part display for Type A, B, and D.
1 / 2 / 3 (Type A, B only)
“Text Select” Selects the information displayed.
Refer to <13-5. Selecting a text display>
(page 60) .
“Graphic Select”
[1]
Sets the Type D Spectrum analysis display.
1 / 2
“Status” Sets the status display (ON/OFF indicator for
each function) for Type A and B.
[2]
“ON” / “ OFF ”
(
Colored text
: Factory setting)
[1]
Function of KDC-X998/ KDC-BT958HD.
[2]
The status display automatically turns “OFF” during aha
source and cannot be switched to ON.
4
Select a setting using [Control] knob.
Returns to the previous item.
Exiting from the Function setting mode
Press and hold [
1
/
6
].