18
ENGLISH
Data Size:
B6L (182 mm x 128 mm)
Book Size:
B6L (182 mm x 128 mm)
Part list for installation
(A)
Faceplate (×1)
(B)
Trim plate (×1)
(C)
Mounting sleeve (×1)
(D)
Extraction key (×2)
(E)
Wiring harness (×1)
(F)
Screws
M5 × 7 mm (×4)
M5 × 6 mm (×4)
M4 × 8 mm (×1)
INSTALLATION/CONNECTION
Installing the unit (in-dash mounting)
Installing the unit (without mounting
sleeve)
1
Remove the mounting sleeve and trim plate from the
unit.
2
Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with
screws (supplied).
Use only the specified screws. Using wrong screws might
damage the unit.
Removing the unit
1
Detach the faceplate.
2
Fit the catch pin on the extraction keys into the holes
on both sides of the trim plate, then pull it out.
3
Insert the extraction keys deeply into the slots on
each side, then follow the arrows as shown on the
illustration.
Bend the appropriate tabs to hold the
sleeve firmly in place.
Hook on the top side
Orientate the trim
plate as illustrated
before fitting.
Dashboard of your car
Do the required wiring.
(Page 19)
Basic procedure
1
Remove the key from the ignition switch, then
disconnect the
terminal of the car battery.
2
Connect the wires properly.
See “Wiring connection” on page 19.
3
Install the unit to your car.
See “Installing the unit (in-dash mounting)”.
4
Connect
the terminal of the car battery.
5
Press
B
SRC to turn on the power.
6
Detach the faceplate and reset the unit.
(Page 3)
JS_KWD_KDC_230UI_MN_M2N_EN_3rd.indd 18
JS_KWD_KDC_230UI_MN_M2N_EN_3rd.indd 18
7/18/2018 3:51:43 PM
7/18/2018 3:51:43 PM
