KDC-C517FM, C717/Y
9
ADJUSTMENT
RF MODULATOR UNIT
1. DC balance adjustment (VR301)
While observing the waveform with an
oscilloscope at pin 13 of IC301, adjust VR301 to
minimize the waveform level.
2. PLL control voltage adjustment (VC301)
First set the transmission frequency to
∗
87.9
MHz with the commander, then adjust VC301 so
that the DC Voltage at the + pole of C317,
measured using a multi-meter or digital tester, is
+ 3V (
±
0.1 V).
∗
NOTE: E type is 87.7MHz.
3. Modulation level adjustment (VR303)
The method uses a standard receiver or tuner.
Adjust VR303 so that the output level from the standard receiver or tuner is as specified.
L.P.S. initial position adjustment procedure
1. Connect the changer to the H/U.
2. While holding the magazine eject button of
the changer, press the reset button of the
H/U.
3. After about 3 seconds, release the magazine
eject button.
4. Press the SRC button of the H/U to enter the
CD-CH mode, and the H/U's display section
indicates "E-88".
5. Move the mechanism deck to around the 1st
stage by pressing the DISC- or DISC+ button.
6. Insert the adjustment tool (W05-0635-00) into
the tool hole on the changer mechanism.
7. Then press the DISC+ button to move the
mechanism deck until the mechanism's slider
8. When the motor locks (stops), press the
When the REPEAT key is pressed, the
mechanism moves automatically to the 1st stage and the initial position adjustment completes. (The data is
written in the EEPROM at this time.)
W05-0635-00
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
