1. To prevent a short circuit, remove the key from the ignition and
disconnect the
-
battery.
2. Make the proper input and output wire connections for each unit.
3. Connect the wiring harness wires in the following order: ground,
battery, ignition.
4. Install the unit in your car.
5. Reconnect the
-
battery.
6. Press the reset button.
When drilling a hole in the car chassis to install the unit, check
first that nothing is on the other side.
• If the fuse blows, first make sure the wires aren’t touching to
cause a short circuit, then replace the old fuse with one with
the same rating.
• Do not let unconnected wires or terminals touch metal on the
car or anything else conducting electricity. To prevent a short
circuit, do not remove the caps on the ends of the
unconnected wires or the terminals.
• After the unit is installed, check whether the brake lamps,
blinkers, wipers, etc. on the car are working properly.
• Insulate unconnected wires with vinyl tape or other similar
material.
• Some disc changers require optional equipment for connection.
See the section on "Safety Precautions" for details.
2
CAUTION
2
WARNING
Accessories
Installation Procedure
External view
Number of items
................................................1
2
................................................2
1
................................................1
3
The use of any accessories except for those provided might result in
damage to the unit. Make sure only to use the accessories shipped with
the unit, as shown above.
— 17 —
KCA-R71FM_U.S_r3 04.7.8 3:58 PM Page 17
