Kenwood K-525, Instruction Manual

Page: 20 / 27

K-525
38 39
English
System Setup
Ad
vanc
ed oper
ations
Setting the display saver
(DISP. SAVER)
When this unit has not been controlled for a certain
period of time, the display scrolls to prevent burns
and brightness irregularities from being produced
on the display panel.
1
Enter the setup mode.
Press [MODE].
2
Select "DISP. SAVER".
Press [
G
]/[
H
] to select,
then press [ENTER].
3
Set Display Saver.
Press [
G
]/[
H
] to select,
then press [ENTER].
D. SAVER ON
D. SAVER OFF
Display Saver is OFF.
Display Saver is ON.
When the setting completes, the unit exits the
setup mode automatically.
• When the input source is CD/USB, Display Saver is
activated when the unit has not been controlled for 10
minutes after the end of the last playback. With other
inputs, Display Saver is activated when the unit has
not been controlled for 10 minutes after a button is
pressed.
Setting Auto Power Save
(A.P.S. SET)
A.P.S. stands for Auto Power Save, which is the function
that switches this unit OFF when it has not been
controlled for more than 30 minutes while its power is
ON and the CD and other inputs are in stop mode.
1
Enter the setup mode.
Press [MODE].
2
Select "A.P.S. SET".
Press [
G
]/[
H
] to select,
then press [ENTER].
3
Set the A.P.S. mode to ON/OFF.
Press [
G
]/[
H
] to select,
then press [ENTER].
A.P.S. ON
A.P.S. OFF
A.P.S. mode is OFF.
A.P.S. mode is ON.
When the setting completes, the unit exits the
setup mode automatically.
" " lights when A.P.S. is set to ON.
■
When the A.P.S. mode is ON...
A.P.S. is activated when this unit is in either
condition below.
• When the input source is TUNER, AUX, D.AUDIO, iPod
or DIGITAL IN, the volume level is 0 and no button has
been pressed for 30 minutes.
• When the input source is CD or USB, the CD player or
USB device is in stop mode and no button has been
pressed for 30 minutes.
Adjusting the recording output
level (Rec Out LEVEL)
If the audio recorded on the component connected
to the [REC OUT] connector is distorted or too low,
adjust the recording output level.
1
Select the input source to be output
at the recording output.
2
Enter the setup mode.
Press [MODE].
3
Select "RecOut LEVEL".
Press [
G
]/[
H
] to select,
then press [ENTER].
4
Adjust the recording output level.
Press [
G
]/[
H
] to select,
then press [ENTER].
The recording level can be adjusted as desired in
the range between –2 and +2.
Display when the recording output level is "+2".
When the setting completes, the unit exits the
setup mode automatically.
Setting the brightness of the
display (DIMMER)
The brightness of the display can be set as desired.
1
Sets the display brightness.
Press [DIMMER].
Each press switches the dimmer mode alternately.