Kenwood HM-337, Instruction Manual

Page: 8 / 20

8
EN
Demonstration mode
The system is equipped with a demonstration
function (only display). The demonstration consists
of sequential change of display and indicators
showing the operations, but the audio itself does
not change. The demonstration function can be
cancelled as follows.
To deactivate the demonstration
• Press and hold rec button ( REC/DEMO button
on the remote control) for more than 0.8
seconds during demonstration.
To activate the demonstration
• After turning the power on, press and hold rec
button ( REC/DEMO button on the remote
control) for more than 0.8 seconds.
Note:
The demonstration operates automatically when a
power failure has occurred, or the plug of the power
cable has been pulled out while the power was on.
Switching the system on
Press button on the unit or POWER button
on the remote control; or CD , TUNER/band
( TUNER/BAND on the remote control), or TAPE
button and the standby led will go out.
• The system will switch to the last selected
source or the selected source.
Switching the system to standby
mode
Press or button on the unit or POWER button
on the remote control.
Volume control
Press volume
∧ ∧
∧ ∧ ∧ button on the unit (
button on the remote control) to increase or press
volume
∨ ∨
∨ ∨ ∨ button on the unit ( VOLUME – button
on the remote control) to decrease the volume
level.
"vol XX" will be displayed. "vol XX" denotes the
volume level.
The volume can be adjusted in 31 steps from
minimum to maximum.
Basic function
To switch off the volume temporarily
Press MUTE button on the remote control.
Playback will continue without sound only system
speaker output and the icon "MUTE" appears on
the display.
To restore the volume, press
MUTE button on the
remote control again or adjust the volume.
Sound control
EQ/X-BASS
The sound control system feature enables you to
enjoy special sound effects that have preset
equalizer settings, providing the best music
reproduction.
Press EQ/X-BASS button
To select the desired sound effect: POP, CLASSIC,
ROCK, JAZZ or FLAT.
To switch the X-BASS on/off
Press and hold the EQ/X-bass button on the unit
( EQ/X-BASS button on the remote control).
If X-BASS is switched on, "BASS ON" will appear
then disappear on the display and the icon "X-
BASS" will appear on the display. If X-BASS is
switched off, "BASS OFF" will appear then
disappear on the display and the icon "X-BASS"
will disappear.
Headphones
To listen to your stereo with headphones (not
included), use the 3.5 mm
phones jack on the
top of the unit.
5467/08-20/EN 04.5.26, 3:06 PM 8