PARENTAL LOCK / DISASSEMBLY FOR REPAIR
(L3)
hole A
FIG. 1-1
FIG. 2-2
3
DVF-3400
How to Reset Parental Lock
1. Connect the TV set to DVF-3400.
2. Push the power switch of DVF-3400 to be on.
3. Check the display of DVF-3400 shown “NO DISC”.
4. Push the “SETUP” key of remote control and TV has “set
up menu”.
5. Select the “16:9” on TV.
6. Push # key 1397139 and ENTER. Push # key again if
mistype.
7. Push the power switch of DVF-3400 to be off.
1. TRAY DISC (FIG. 1-1)
1) Insert and push a Driver in the emergency eject hole (A)
at the right side, or put the Driver on the Lever (B) of the
Gear Emergency and pull the Lever (B) in direction of
arrow so that the Tray Disc is ejected about 15~20mm.
2) Pull the Tray Disc until it is separated from the Base Main
completely.
2. FRAME ASSEMBLY UP/DOWN (FIG. 2-2)
Note
Put the Base Main face down (Bottom Side)
1) Release the screw (S4)
2)
Unlock the Locking Tab (L3) in direction of arrow and
then lift up the Frame Assembly Up/Down to separate it
from the Base Main.
Note
• When reassembling move the Guide Up/Down in direction
of arrow (C) until it is positioned as Fig. (C).
• When reassembling inser t (A) por tion of the Frame
Assembly Up/Down in the (B) portion of the Guide Up/
Down as Fig. (B)
3. BELT LOADING (FIG. 2-2)
Note
Put the Base Main on original position (Top Side)
4. GEAR PULLEY (FIG. 2-2)
1) Unlock the Locking Tab (L4) in direction of arrow (B) and
then separate the Gear Pulley from the Base Main
5. GEAR LOADING (FIG. 2-2)
6. GUIDE UP/DOWN (FIG. 2-2)
1) Move the Guide Up/Down in direction of arrow (A) as Fig.
(A)
2) Push the Locking Tab (L5) down and then lift up the Guide
Up/Down to separate it from the Base Main.
Note
When reassembling place the Guide Up/Down as Fig. (C)
and move it in direction arrow (B) until it is locked by the
Locking Tab (L5). And confi rm the Guide Up/Down as Fig. (A)
7. PWB ASSEMBLY LOADING (FIG. 2-2)
Note
Put the Base Main face down (Bottom Side)
1)
Release 1 Screws (S5)
2)
Unlock the Loading Motor (C2) from the Hook (H1) on
the Base Main.
3)
Unlock 2 Locking Tabs (L6) and separate the PWB
Assembly Loading from the Base Main.
