Kenwood DRV-A301W, Instruction Manual

Page: 16 / 73

13
DC-IN/Data transfer Port
By connecting the device with the supplied cigar lighter adapter cable you are
able to charge the device. This will also be utilized to let you connect the USB cord to
your computer. You can either connect the cigar lighter adapter cable with the device
or magnetic connector.
Microphone
Built-in microphone for audio recording.
Reset Button
On the rare occasions the device has a problem, use the reset button to shut down
the device. Simply press the reset until the device turns off and the device will
automatically turn on.
14.
15.
16.
Recommended installation position
Install the device in a position where it will not block the front view of the driver
(position where hidden by the rear-view mirror).
Install the device so that it is within the wiping range of the wiper.
Mounting the device to the center of the windshield behind the rear-view mirror
will facilitate optimal video recording.
Caution
When passing the power cord through the front pillar or another part, observe the
points below when performing the wiring work.
Wire the power cord farther forward or farther rearward than the airbag so that it
does not interfere with the airbag.
In the case of a vehicle in which the front pillar cover is fixed in place with special
clips or the like, the clips may need to be replaced after you remove the front pillar
cover. For how to remove the front pillar cover, the availability of replacement
parts and other information, contact the vehicle dealer.
Fix the power cord in place with commercially available soft tape or the like so that
it does not interfere with driving.
Installation and Connection
Left-hand Drive Right-hand Drive
•
•
•
•
•
•