24
Data Size:
B6L (182 mm x 128 mm)
Book Size:
B6L (182 mm x 128 mm)
Do the required wiring. (
25, 26
)
Dashboard of your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
Installing the unit (in-dash mounting)
When installing without the
mounting sleeve
1
Remove the mounting sleeve
from the unit.
2
Align the holes in the unit (on
both sides) with the vehicle
mounting bracket and
secure the unit with screws
(commercially available).
Use only the specified screws. Using
wrong screws might damage the unit.
How to remove the unit
1
Fit the catch pin on the extraction keys
into the holes on both sides of the trim
plate, then pull it out.
2
Insert the extraction keys deeply into
the slots on each side, then follow the
arrows as shown below.
Warning
•
The unit can only be used with a 12 V DC power supply, negative ground.
•
Disconnect the battery’s negative terminal before wiring and mounting.
•
Do not connect Battery wire (yellow) and Ignition wire (red) to the car
chassis or Ground wire (black) to prevent a short circuit.
•
Insulate unconnected wires with vinyl tape to prevent a short circuit.
•
Be sure to ground this unit to the car’s chassis again after installation.
Caution
•
For safety’s sake, leave wiring and mounting to professionals. Consult
the car audio dealer.
•
Install this unit in the console of your vehicle. Do not touch the metal
parts of this unit during and shortly after use of the unit. Metal parts
such as the heat sink and enclosure become hot.
•
Do not connect the
[
wires of speakers to the car chassis or Ground
wire (black), or connect them in parallel.
•
Mount the unit at an angle of less than 30º.
•
If your vehicle wiring harness does not have the ignition terminal,
connect Ignition wire (red) to the terminal on the vehicle’s fuse box
which provides 12 V DC power supply and is turned on and off by the
ignition key.
•
Keep all cables away from heat dissipate metal parts.
•
After the unit is installed, check whether the brake lamps, blinkers,
wipers, etc. on the car are working properly.
•
If the fuse blows, first make sure the wires are not touching car’s chassis,
then replace the old fuse with one that has the same rating.
Basic procedure
1
Remove the key from the ignition switch, then
disconnect the
[
terminal of the car battery.
2
(For
)
Install the DAB antenna.
See Installing the DAB antenna. (
27)
3
Connect the wires properly.
See Wiring connection. (
25, 26
)
4
Install the unit to your car.
See Installing the unit (in-dash mounting).
5
Connect the
[
terminal of the car battery.
6
Reset the unit. (
3
)
INSTALLATION / CONNECTION
JS_KWD_DPX406DAB_DPX306BT_EN_EN_1.indd 24
JS_KWD_DPX406DAB_DPX306BT_EN_EN_1.indd 24
15/10/2014 12:09:50 PM
15/10/2014 12:09:50 PM
