Kenwood DPX-302, Instruction Manual

Page: 27 / 44

27
XD SERIES (En)
Operation
To pause recording
(Main unit only)
÷
Pressing the key pauses recording after leaving a non-
recorded space of about 4 seconds.
÷
If the key is pressed again in less than 4 seconds after it has
been pressed, recording resumes from that instant.
Lit
TAPE A/B
REC/ARM
÷
This unit cannot record on a high-position (Type
II
) tape or metal
tape.
÷
Remove tape slack before loading.
÷
When recording is started, the tape is transported in the
direction selected in this step.
÷
Wind the tape to the position where recording is to be started.
Check the tape transport direction indicator.
∞
The input source component
to be recorded should be dis-
played.
÷
If a disc has already been loaded when the CD input is
selected, it will starts to play automatically. In this case,
press the stop (
7
) key to stop it.
C 2 D 0 1 1 : 1
÷
Even if deck A is selected, it is automatically switched to deck
B at the start of recording.
÷
Recording stops automatically when the tape side(s) to be
recorded have been fully recorded.
÷
Press the stop (
7
) key of the cassette deck unit to stop recording.
Selection of reverse mode
1
Select the “Tape Options”.
2
Select the “Reverse Mode”.
3
Select desired mode.
MENU
SELECT
SELECT
SELECT
1
“ ” ........ Recording stops after having recorded
one side of tape.
2
“ ” ...... Recording stops after having recorded
both sides of tape.
3
“ ” ..... Recording stops after having recorded
both sides of tape.
÷
When the “
2
” transport direction indicator is lit, recording
always stops after having recorded one side of tape.
When Recording from a CD
Beat cancel function
There may be cases in which beat noise interferes with
recording of AM (MW)/LW broadcasting.
Switch to "Beat Cancel" before recording the program
you want to record. Make a trial recording and then
record where the transmission noise is lowest.
Recording (Deck B only)
The unit is equipped with handy functions for recording
from a CD. For details, refer to page 29.
1
Start recording an AM broadcast.
2
Press the Tape A/B key.
3
Listen to the sound on the trial re-
cording and select the best sound.
1
“Beat Cansel on”
2
“Beat Cansel off”
TAPE A/B