2
|
DNX520VBT
Installation Procedure
1
..........1
2
..........1
3
..........1
4
..........1
5
†
..........1
6
†
..........2
7
†
..........1
†
This accessory is used when connecting an external device
to AV-IN jack on the front panel of this unit. For how to use
this accessory, refer to the instruction manual of this unit.
Accessories
1. To prevent short circuits, remove the key from the
ignition and disconnect the
-
terminal of the
battery.
2. Make the proper input and output wire
connections for each unit.
3. Connect the wire on the wiring harness.
4. Take Connector B on the wiring harness and
connect it to the speaker connector in your vehicle.
5. Take Connector A on the wiring harness and
connect it to the external power connector on your
vehicle.
6. Connect the wiring harness connector to the unit.
7. Install the unit in your car.
8. Reconnect the
-
terminal of the battery.
9. Press the reset button.
2
WARNING
• If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those
wires to the power source running through the fuse box.
Acquiring GPS Signals
The first time you turn on DNX520VBT, you must wait
while the system acquires satellite signals for the first
time. This process could take up to several minutes.
Make sure your vehicle is outdoors in an open
area away from tall buildings and trees for fastest
acquisition. After the system acquires satellites for the
first time, it will acquire satellites quickly each time
thereafter.
After the Installation
After the installation, perform the Initial Setup by
referring to the instruction manual.
B54-4771-00̲00̲DNX520VBT̲E.indb 2
B54-4771-00̲00̲DNX520VBT̲E.indb 2
09.12.18 4:30:39 PM
09.12.18 4:30:39 PM
