Kenwood DNX4330, Instruction Manual

Page: 4 / 66

66 7
Return to the Top page
Basic Operations
Return to the Top page
Basic Operations
F
unctions of the Buttons on the Front Panel
DNX7330BT/DNX7330BTM
1 2
3
4
5 6 7 8 9
11
10
NOTE
• The panels shown in this guide are examples used to provide clear explanations of the operations. For this reason,
they may be different from the actual panels.
• In this manual, each model name is abbreviated as follows.
DNX7330BT, DNX7330BTM :
If above icon is showed, read the article applicable to the unit you use.
How to insert an SD Card
1) Press
8
<
0
> button for 1 second.
The panel fully opens.
2) Hold the SD card as the illustration in the right
and insert it into the slot until it clicks.
●
To eject the card:
Push the card until it clicks and then remove your finger
from the card.
The card pops up so that you can pull it out with your
fingers.
B
asic Operations
Number Name Motion
1
fi
(Reset) • If the unit or the connected unit fails to operate properly, the unit
returns to factory settings when this button is pressed (P.115) .
• If the Security Indicator (SI) function is turned on, this indicator flashes
when the vehicle ignition is off (P.85) .
2
ATT • Switches attenuation of the volume on/off.
• Pressing for 1 second turns the screen off.
3
∞
,
5
(Vol) Adjusts volume.
4
AUD • Displays Graphic Equalizer screen (P.101) .*
• Pressing for 1 second switches camera view display on/off.
5
NAV • Displays the navigation screen.
• Pressing for 1 second switches AV out sources.
6
MENU • Displays the Top Menu screen (P.16) .
• Pressing for 1 second turns the power off.
• When the power off, turns the power on.
7
TEL • Displays the Hands Free screen (P.68) .
• Pressing for 1 second displays the Voice Recognition screen. (P.76)
8
0
(Eject) • Ejects the disc.
• When the panel is opened, pressing closes the panel and pressing for 1
second ejects the disc forcibly.
• When the panel is closed, pressing for 1 second fully opens the panel to
the location of the SD card slot.
9
Remote
Sensor Receives the remote control signal.
10
Disc insert
slot A slot to insert a disc media.
11
SD card slot An SD card slot for upgrading the map. For how to upgrade the map, refer
to the instruction manual of the navigation system.
* The display may not switch to the Graphic Equalizer screen in some conditions.
0
Labelled
side