Connection/Installation
18
8
Attach the protective cover (accessory
=
)
to coupling part, and then fix it with two
binding head screws (accessory
~
).
~
=
NOTE
• If the protective cover (accessory
=
) is not
attached, this unit will not turn on. Even if the
unit is turned on, the power may be turned off
halfway.
Be sure to attach the protective cover (accessory
=
).
9
Raise the display manually.
Ñ
Wiring harness (Accessory
1
)
connector function guide
Pin
Color and function
A-4
Yellow
Battery
A-5
Blue/White
[2]
Power Control
A-6
Orange/White Dimmer
A-7
Red
Ignition (ACC)
A-8
Black
Earth (Ground) Connection
B-1/B-2 Purple (+) / Purple/Black (–) Rear Right
B-3/B-4 Gray (+) / Gray/Black (–)
Front Right
B-5/B-6 White (+) / White/Black (–)
Front Left
B-7/B-8 Green (+) / Green/Black (–)
Rear Left
*Speaker Impedance: 4-8 Ω
[1] [2]: Blue/White wire is provided two wires, [1] and [2].
Blue/White wire total output ([1] + [2]):
12 V
=
350 mA
#
WARNING for Connecting the ISO
Connector
The pin arrangement for the ISO connectors depends
on the type of vehicle you drive. Make sure to make
the proper connections to prevent damage to the
unit. The default connection for the wiring harness is
described in (1) below. If the ISO connector pins are set
as described in (2), make the connection as illustrated.
Please be sure to reconnect the cable as shown (2)
below to install this unit to the Volkswagen vehicles etc.
(1): Default setting
The red (A-7 pin) of the vehicle’s ISO connector is linked
with the ignition, and the yellow (A-4 pin) is connected
to the constant power supply.
Red (Ignition cable)
Yellow (Battery cable)
Yellow (A-4 pin)
Red (A-7 pin)
Unit
Vehicle
(2)
The red (A-7 pin) of the vehicle’s ISO connector is
connected to the constant power supply, and the
yellow (A-4 pin) is linked to the ignition.
Red (Ignition cable)
Yellow (Battery cable)
Yellow (A-4 pin)
Red (A-7 pin)
Unit
Vehicle
!B5K-0762-00_20DDX_E_FP_QSG.indb 18
2020/08/04 10:11
Autogoods “130”
130.com.ua
