Kenwood DF520 series, User Manual

Page: 4 / 53

know your Kenwood deep fryer
safety
●
Never plug in the fryer before filling the bowl with oil.
●
Keep children away during use and after - fat stays hot
for a long time.
●
Never let the cord touch hot surfaces or hang down
over the worktop edge - a child could grab it and pull
the fryer down. Place excess cord in cord storage area
at the back of the fryer.
●
Never touch the bowl, pour away oil or move your fryer
while the oil’s hot.
●
Never put the electrics unit in water. Remove it before
washing the rest of your fryer.
●
After cleaning, ensure the bowl and its electric pins are
dry before use.
●
Never leave your fryer on unattended.
●
Take care when removing the electrics unit - the
temperature probes may be hot.
●
Do not use if there is any damage to the fryer, cord or
plug. Get it checked or repaired: see ‘service’.
● Only use the electrics unit supplied.
● Watch out for steam during cooking and when you
open the lid.
●
Never put your fryer near or on cooker hot plates.
●
Always unplug the fryer after use.
●
This appliance is not intended to be operated by
means of an external timer or separate remote-control
system.
●
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
●
Children should be supervised to ensure that they do
not play with the appliance.
●
Only use the appliance for its intended domestic use.
Kenwood will not accept any liability if the appliance is
subject to improper use, or failure to comply with these
instructions.
before plugging in
●
Make sure your electricity supply is the same as the
one shown on the underside of the electrics unit.
●
This appliance conforms to EC directive 2004/108/EC
on Electromagnetic Compatibility and EC regulation no.
1935/2004 of 27/10/2004 on materials intended for
contact with food.
before using for the first time
1 Remove all packaging.
2 Dismantle: see ‘to dismantle, assemble and use your
fryer’.
3 Wash the parts: see ‘cleaning’.
know your Kenwood fryer
removable lid with permanent mesh filter
viewing window
lid seal
condensation trap
rise and fall control
pouring lips
removable bowl
lid release
carrying handles
electrics unit
timer
temperature control with neon light
temperature probes
cord storage
to dismantle, assemble and use
your fryer
to dismantle
1 Push the lid release down to open the lid. Then lift
the lid off.
2 Lift up the handle and remove the basket.
3 Pull out the electrics unit and then remove the bowl.
●
Before removing the electrics unit check that
the cord is released from the cord storage
area at the back of the fryer .
to assemble and use
1 Insert the bowl – ‘MAX’ and ‘MIN’ marks to the back of
the fryer.
2 Then insert the electrics unit – cord to the back of
the fryer + .
3 Pour in the oil. The level must be between the ‘MAX’
and ‘MIN’ marks .
4 Insert the basket and close the lid. Then lower the
handle by sliding back the rise & fall control .
5 Plug in and select the required temperature .
6 The light goes out when the oil reaches the right
temperature to start frying. Fill the basket and lower
into the oil
. Don’t exceed the maximum food
quantities stated. The light will come on and off as
the fryer maintains the temperature.
2