Tool Adjustment
Refer to Illustration
U
K-beater, Whisk and Creaming Beater
The tools are set to the correct height
for the bowl supplied in the factory and
should not require adjustment.
However, if you wish to adjust the tool
use a suitable sized spanner:
TYPE KWL90 = 19mm
Then follow the instructions below:
1
Unplug the appliance.
2 Raise the mixer head and insert the
whisk or beater.
3 Lower the mixer head. If the
clearance needs to be adjusted,
raise the mixer head and remove the
tool. Ideally the whisk and K-beater
should be
almost
touching the
bottom of the bowl.
Creaming Beater
- Ideally it should
be in contact with the bowl surface
so that it gently wipes the bowl
during mixing.
4 Using a suitable spanner loosen the
nut sufficiently to allow adjustment
of the shaft. To lower the tool closer
to the bottom of the bowl, turn the
shaft anti-clockwise. To raise the tool
away from the bottom of the bowl
turn the shaft clockwise.
5 Re-tighten the nut.
6 Fit the tool to the mixer and lower
the mixer head. (Check its position
see points above).
7 Repeat the above steps as necessary
until the tool is set correctly. Once
this is acheived tighten the nut
securely.
Note: Spanner shown is for illustration
purpose only.
Dough Tool
This tool is set at the factory and should
require no adjustment.
Care and Cleaning
O
Always switch off and unplug before
cleaning.
O
A little grease may appear at the
slow speed outlet
when you first
use it. This is normal – just wipe it off.
Power Unit And Outlet Covers
O
Wipe with a damp cloth, then dry.
O
Never use abrasives or immerse in
water.
Bowls
O
Wash by hand, then dry thoroughly
or wash in the dishwasher.
O
Never use a wire brush, steel wool
or bleach to clean your stainless
steel bowl. Use vinegar to remove
limescale.
O
Keep away from heat (cooker tops,
ovens, microwaves).
O
The 5L bowl can be placed in the
7L bowl for easy storage. (Do not
place tools within the 5L bowl when
stacked in the 7L bowl).
Tools And Splashguard
O
Wash by hand, then dry thoroughly
or wash in the dishwasher.
Dishwashing
O
Alternatively see illustrations table at
the front for dishwasher safe parts.
Recipe
Prune Marinade
200g Clear Runny Honey
50g Soft Prunes
50ml Water
1
Place all ingredients into the mini
chopper/mill. Refrigerate overnight.
2 Fit the attachment to the Stand
mixer.
3 Switch to pulse for 5 seconds.
4 Use as required.
13