Kenway 64274 Owner'S Manual & Safety Instructions Download Page 3

Page 3

For technical questions, please call 1-888-866-5797.

Item 64274 

        

IMPORTANT SAFETY INFORMATION

Installation Precautions

1.  Install only according to these instructions.  

Improper installation can create hazards.

2.  Wear ANSI-approved safety goggles and 

heavy-duty work gloves during installation.

3.  Keep installation area clean and well lit.

4.  Keep bystanders out of the area during installation.

5.  Do not install when tired or when under 

the influence of drugs or medication.

6.  Read all instructions and safety precautions 

in the vehicle’s manual onto which the 

Trailer Lights will be installed.

7.  Install on negative ground 12VDC systems only.

8.  Do not install this product yourself unless you are 

technically competent to do so.  If necessary, have 

a qualified technician install the Trailer Lights.

9.  Use the correct lights and electrical setup for your 

trailer.   

If the vehicle is OVER 80

 wide, install 

three additional Red Marker Lights

*

 

(not included) onto the rear of the unit.

10. If the towing vehicle has rear turn signals 

separated from its stop lights, additional hardware 

and installation procedures will be needed.  

Contact a qualified technician for guidance.

Example additional marker light locations: 

Mount the three Red Marker Lights to the rear of the vehicle, 

making sure the Lights are no closer than 6" and no farther 

away than 12" from each other center to center. After mounting, 

use wire nut connectors (not included) to connect all three 

leads together. Then connect to the Brown wire in the back 

of one Tail Light (either side) provided in this Kit.

Use Precautions

1.  This product is not a toy.  Do not allow 

children to play with this item.

2.  Use as intended only.

3.  Inspect before every use; do not use 

if parts are loose or damaged.

4.  Maintain product labels and nameplates.  

These carry important safety information.  

If unreadable or missing, contact 

Harbor Freight Tools for a replacement.

Summary of Contents for 64274









Reviews: