
Page 3
Item 56216
For technical questions, please call 1-888-866-5797.
Installation
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.
1. This product can be mounted
on the top of a cab, along a
running board, or along the side
of a vehicle, trailer, or boat
2. The planned mounting area
must provide a flush fit to the
bottom of the Lights.
3. Remove the lens from each Light
and use the base of the Light as a
template to mark mounting holes.
4. Ensure that the installation
area has no hidden electrical or
stereo lines before drilling.
5.
Drill the 1/8″ holes for the screws
and a 1/4″ hole for the wire.
Secure each of the Lights with two
Screws (2). Replace the lens.
6. Connect the wire of each of the
Lights to the Lead Wire (4) using a
Wire Splice (3). Insert the two wires
into the holes of the Splice and use
pliers (not included) to push down the
metal tab. Close the cap to secure.
Holes for
Wires
Metal Tab
Cap
Wire Splice (3)
7. Connect the lead wire to the headlight,
tail light, or parking light switch
positive terminal as appropriate.
8. Installation of these products
must comply all applicable
State and local laws.
(Switch Not Included)
Light
Lead Wire
12VDC
Ground
+
_
Light
Lead
Wire
12 VDC
Ground
Switch
(not included)