Electrode sheet (optional)
USB
charging
cable
How to Operate
1. Powersupply
1) USB power supply
Insert the output end plug of the Micro USB cable into the lower hole
(DC interface) of the massager, and then plug the input end pin of the
Micro USB cable into the mobile phone charger or power bank (5V
DC 1A or 2A)
1
）
Built-in rechargeable battery power supply
。
When no external
power supply is needed, the built-in rechargeable battery can supply
power
2
）
Remote control battery installation
Install the button battery CR2032 in the battery compartment on the
back of the remote control. The installation method is as shown in
①
-
②
as shown in the figure below. Use your fingers to unscrew the
battery cover from the groove of the battery cover, and turn the button
battery CR2032 front (po) upward , Put it in the battery
compartment of the remote control, insert the positioning pin on the
top of the battery cover first, and then press the battery cover tightly.
2
、
Function operation
1
）
Wet the cervical spine and the conductive sheet with a wet towel,
and then put the massager close to the neck. If there is sweat on the
cervical spine, it must be cleaned before use.
2
）
Press the host key " " to enter the waiting state for signal
reception, and the main unit's working indicator flashes (the main
unit maintains the waiting signal reception state for 1 minute, and it
will automatically shut down if it does not receive a remote control
signal within 1 minute) Press the "" button on the remote control to turn
on, the main unit will beep once, the screen backlight will light up, and
the main unit work indicator will stay on, that is, the following settings
are available:
A
、
Automatic combination mode 1 massage
Installation
