11) Using arpeggio clock. With the rear panel toggle switch in the UP position, the Juno 6 will function as normal.
With the switch in the DOWN position the Juno 6 will use MIDI clock. You may need to set the divide rate
– see the
first page. If you want to use the external jack input for clock, you should set the switch in the up position.
To select MIDI clock merely set the rear panel switch to the DOWN position and the arpeggiator will take its tempo
from MIDI. Note that if the switch is set to MIDI and there is no MIDI clock present, the Juno 6 will not play, if it is in
arpeggio mode.
To change the divide rate, press the push button and hold in for about four seconds, until a note sounds, (this is
transpose mode) the bottom four octaves are used to set "transpose" but the top octave will set the arpeggio divide.
TOP C = ENTER - Return to normal playing and store
B = Clock normal - no divide (full speed)
Bb = Clock divided by 2 (half speed)
A = Clock divided by 4 (quarter speed)
Ab = Clock divided by 8 (eighth speed)
G = Set triplet on (can be used with any of above)
You will need to press TOP C (Enter) after any selection.
If you want to use Triplet, you will need to set this after the divide ratio, as pressing any of the divide ratios cancels
Triplet.
GENERAL INFORMATION ABOUT MIDI CONNECTIONS
Any MIDI IN should be connected to a MIDI OUT or a MIDI THRU similarly any MIDI OUT should be connected
only to a MIDI IN and any MIDI THRU should also only be connected to a MIDI IN.
MIDI OUT (if fitted) is the signal from the synthesizer (or drum machine etc.) that is to be sent to another
instrument. MIDI IN is a received signal that contains MIDI information from another synth, and MIDI THRU is an
exact copy of information arriving at the MIDI IN socket. This allows several instruments to be connected together.
If you want to wire your own MIDI cables the following information may be useful.
1) Although a 5 pin connector is used, only two connections plus an
earth connection are required.
2) If you look at the din plug from the wiring side you will see that the pins are numbered. From left to right (or
clockwise) these are 1 - 4 - 2 - 5 - 3.
3) The pins numbered 1 & 3 are not used.
4) The screen (earth) is connected to pin 2 (centre pin)
5) Pin 4 of one plug should be connected to pin 4 of the other
6) Pin 5 of one plug should be connected to pin 5 of the other
7) You should now have a working MIDI lead
8) It is preferable to label one end of the cable MIDI IN & the other end MIDI OUT, to avoid confusion.
WARRANTY
All Kenton MIDI Kits come with a 12 month (from purchase date) back to base warranty, (i.e. customer must
arrange and pay for carriage to and from Kenton Electronics). Note that kits should be fitted as soon as possible
after purchase, as the retrofit kits are in a continuous state of development.
Kenton Electronics Limited
Unit 13, First Quarter, Blenheim Road, Epsom, Surrey KT19 9QN, UK
Tel: +44 (0)20 8544 9200 Fax: +44 (0)20 8544 9300
www.kenton.co.uk
E & OE Copyright (c) KENTON Electronics & John Price 1986-2021
