6
5
The unique TDS control system enables customers to retain natural minerals in the purified water as
per the requirement.
• To increase the TDS level (mineral contents), turn the screw of the valve anticlockwise
• To decrease the TDS level (mineral contents), turn the screw of the valve clockwise
TDS Adjustment*
* Tested & Certified by TUV-SUD South Asia (P) Ltd.
• Automatically shuts off water purification process when the storage tank is full
• Does not start water purification process when the inlet water supply pressure is below
2
0.3kg/cm
• Restarts water purification process when the water level drops below the maximum level
• Stops water purification process in the absence of electricity, thus ensuring that a user gets
only purified water
• Resumes water purification process once the electrical supply is available
• Water cooling is ceased when temperature drops to 7
°
C
Automatic Operation
1.
3-Way Connector
:
01 No.
2.
S.S. Ball Valve
:
01 No.
3.
Food Grade Pipe 3/8 inch (White)
:
2.5 Meters
4.
Food Grade Pipe 3/8 inch (Blue)
:
2.5 Meters
5.
Instruction Manual
:
01 No.
Items in the Box
1. Unpack machine and place it on a levelled surface.
2. Fix the S.S. ball valve to the
¼
inch port of the 3-way connector
as shown in the figure.
3. Connect the 3-way connector to the raw water supply as
shown in the figure. The threaded end of the 3-way connector
is fitted in line with the raw water supply. The other end can be
connected to a tap or can be plugged off if not required.
4. Now connect one end of the first fitting to the S.S. ball valve
and other end to the lower pushfit fitting on the back side of the
dispenser labelled as water in. (Note: White pipe is for raw
water supply)
5. Similarly, connect one end of the blue pipe to the second fitting connector and leave the other
end in the drain. (Note: Blue pipe is for reject water)
6. Before connecting the power supply, it is important that you perform the following functions:
(I) Open the S.S. ball valve (handle parallel to the ball valve) to start the flow of water into the purifier.
(II) Wait for 2-3 minutes to ensure that the filters are soaked in water.
7. Insert the power cord into the socket and then turn on the switches. Do not turn on the switches
at the same time. The LED on the front panel then flashes to indicate that the system is ready to
use (each LED light is having a different switch).
8. The system and installation needs to comply with state & local laws & regulations.
Installation Instructions
Electrical Circuit Diagram KENT Perk
