Installation Instructions
To ensure purer water throughout the service cycle, KENT MAXX is equipped with an in-
built UV Fail Alarm which gets activated in an event of UV lamp failure. In case the UV lamp
malfunctions, the purification process automatically stops and purifier starts emitting a
short beep at an interval of every 2 seconds.
UV Fail Alarm
Under such circumstances, switch off the purifier and call the service technician for help.
The purifier will stop purification in such a situation.
KENT MAXX
has an in-built feature that sounds an audible alarm to indicate the
replacement time of filters. This alarm is audible after 700 hrs of filter use. The Filter
Change Alarm works as follows:
Gives 4 short beeps after every two seconds lasting upto 30 seconds. The alarm gets
activated after every 2 hours of use.
Filter Change Alarm
Under such circumstances, the purifier will not function unless the filters are changed.
2 Sec.
2 Sec.
2 Sec.
2 Sec.
30 Sec.
30 Sec.
Slot holes
Computer Controlled Operation
6
5
KENT MAXX
is a convenient and easy-to-install wall mounting model.
Recommended Site Preparations:
100-300 V AC, 50-60 Hz single phase AC supply not more than 3m away from the
point of installation
Raw water supply with ½ inch nipple not more than 3m away
Installation space as per the dimensions of the purifier
Wall/ plane surface for mounting screws and holding the machine. Avoid
installation on wooden and metallic stands
For optimum inlet pressure, source water tank should be at least 10 ft above the
purifier installed
Install the purifier near a sink for easy availability of inlet water lines
The system and installation must comply with applicable state and local laws &
regulation.
n
n
n
n
n
n
n
Installation Procedure:
1.
Screw in two 10x50 self taping screws, 5.4 inches (138 mm) apart horizontally.
2.
Wall-mount the purifier with the help of slot holes given on the back side.
3.
Fasten the SS ball valve to ¼ inch port of 3-way connector.
4.
Attach threaded end of 3-way connector to raw water supply and
plug off the other end or connect to a tap.
5.
Now connect one end of pipe to SS ball valve and other end to elbow fitting connector
labeled as WATER IN, on the left side of purifier.
6.
Turn on the lever given on SS ball valve to initiate the water flow to purifier.
To ensure the delivery of purer and healthier water, a micro-processor is installed in the
purifier that performs the following functions:-
UV Stabilization Delay:
To ensure that the UV lamp is pre-heated and is working at its
optimum before it starts disinfecting water, the controller provides a two second delay
to UV lamp when a purifier is switched on. During this period, only UV lamp is on and all
other electrical devices of purifier are switched off and no water flows through.
Purification Delay:
To ensure that the water lying idle in the internal pipes and the UV
chamber is thoroughly disinfected before being passed onto the storage tank, the
system provides approximately 5 seconds Purification Delay when the purifier is
switched on. During this period, all electrical devices except UV lamp are switched off
and UV lamp kills the micro-organisms present in water inside the UV chamber. After this
delay, all other electrical devices such as solenoid valve etc., get activated and the
normal purification process starts.
Audible Alarm:
Microprocessor also controls the activation of UV Fail Alarm and Filter
Change Alarm.
Please call the service technician once the Filter Change Alarm is activated and get the filters
replaced. In case the filters are not replaced within next 60 hours of operation, the purifier
stops functioning to avoid the delivery of impure water and emits a beep continuously.
