13
Setting Surface Controls
Setting the Dual Ring Burner
The Dual Ring Burner has two rings of
fl
ame that you can
control for two di
ff
erent heat levels, one for small and one
for large cookware.
Large Cookware Operation (Figure 1; Zone A & B)
1. Place a large cooking
utensil centered over
the dual surface Burner
Grate.
2. Push the surface control
knob down and turn
counterclockwise
out of
the OFF position.
3. Release the knob and
rotate to the
LITE
position (Figures 2 & 3).
4.
Visually check that the
burner has lit.
5. When the burner is lit,
continue to turn the
control knob
counterclockwise
between the HI position
and the MED position to adjust to the desired
fl
ame
size for both burners together (Figure 1).
Simmering Operation (Figure 1; Zone A)
1. Place a small cooking utensil centered over the dual
surface Burner Grate.
2. Push the surface control knob in and turn
counterclockwise
out of the OFF position (Fig. 2 & 3).
3. Release the knob and rotate to the
LITE
position.
4.
Visually check that zone A & B of dual burner has lit.
5. Continue to turn the gas control knob counterclockwise
past the MED position; zone B will turn o
ff
. Adjust the
simmer
fl
ame size by turning the control knob between
the
MED position to the LO position
.
Turn
Counterclockw
ise
Figure 2
Figure 4
Figure 3
Important notes:
•
DO NOT
cook with the surface control knob left in the
LITE position. (The electronic ignitor will continue to spark
if the control knob setting remains in the LITE position).
• When setting any surface control knob to the LITE
position, all electronic surface ignitors will spark at the
same time. However, only the surface burner you are
setting will ignite.
•
NEVER
place or straddle a cooking utensil over two
di
ff
erent surface cooking areas at the same time. This
can cause uneven heating results.
Figure 1
B
A
