31
1. Press
.
2. Allow enough time for the oven to cool and for the
door
OPn
message to appear (Fig. 4). When this message
turns OFF the oven door may be opened.
3. Restart Flex Clean if needed (See important notes
below).
If it becomes necessary to stop Flex Clean when active:
Flex Clean
Delayed Start Flex Clean
1. Be sure the clock is set with the correct time of day, the
oven is empty and ALL oven racks are removed. Be sure
oven door is completely closed.
2. Press
Delay Start
keypad.
3. Using numeric keypad enter
9 0 0
for time to start.
4. Press
to accept.
5. Press
Flex Clean
keypad.
6. Press
.
Example — To start a delay Flex Clean with default clean
time of 3 hours and a start time of 9:00 o’clock:
Important notes:
• The kitchen area should be well ventilated using an open
window, ventilation fan or exhaust hood during the 1st
self-clean cycle. This will help eliminate the normal odors
associated with the 1st self-clean cycle.
• When the clean time finishes the oven door will remain
locked until the range has cooled sufficiently. In addition
to the clean time that was programmed, you must allow
about 1 additional hour for the oven to cool before you
will be able to open the oven door.
• The Flex Clean function will not operate whenever a
radiant surface element is ON or the oven lockout is
active.
Important notes:
• If Flex Clean is active and then interrupted by power
failure or cancelled before the oven was thoroughly
cleaned, it may be necessary to run a self-clean cycle
again. If the oven temperature was high enough when
interrupted you may need to allow up to 4 hours before
Flex Clean can be started again.
• When Flex Clean function is active you may check the
amount of clean time remaining by pressing the Flex
Clean keypad once.
• If your control is set with the default 12 hour display
mode, the Delay Flex Clean can only be set to start up to
11 hours and 59 minutes in advance. To set a Delay Start
Flex Clean to begin 12 or more hours (maximum is 23
hours and 59 minutes) in advance, be sure to set the
control for 24 hour display mode.
As soon as Flex Clean becomes active, a motor driven
lock mechanism will begin locking the oven door
automatically.
door Loc
will appear in the display (See
Fig. 1).
DO NOT
open the oven door when
door Loc
is
displayed (allow 15 seconds for the lock mechanism to
lock the oven door).
Once the oven door has locked,
CLn
will appear in the
display indicating Flex Clean has started (Fig. 2).
Fig. 1
Fig. 2
1.
CLn
message will turn off and
Hot
will appear in display
window (See Fig. 3).
2. Once the oven has cooled down (about 1 hour) and
Hot
is no longer displayed the
door OPn
message will
appear (Fig. 4).
When this message turns off the oven
door may be opened.
3. When the oven interior has completely cooled, wipe
away any residue or powdered ash with a damp cloth
or paper towel.
Use caution when opening the oven door
after self-cleaning. The oven may still be
VERY HOT
and can cause burns.
To avoid possible burns stand to
the side of the oven when opening the oven door to
allow hot air or steam to escape.
When Flex Clean is finished:
Fig. 3
Fig. 4
