Kenmore 796.405190, Service Manual

Page: 15 / 59

14
5-3. CYCLE OPTIONS
STAIN TREAT
Use this option for heavily soiled loads that need improved stain treatment. When STAIN TREAT is selected,
the water temperature for the selected cycle will begin as warm water to help prevent the setting of certain
types of stains. Then as the cycle progresses, the water will be heated to higher temperatures to help remove
stains that require treatment at higher temperatures. This option is designed for optimum stain removal.
NOTE: If STAIN TREAT is selected with the SANITIZE cycle, the cycle will begin with very hot water since that
is default for that cycle and cannot be changed.
DELAY START
Once you have selected the cycle and other settings, press this button to delay the start of the wash cycle.
Each press of the button increases the delay time by one hour, for up to 19 hours. Once the desired delay time
is set, press the START/PAUSE button to start the delay time. If the START/PAUSE button is not pressed
within 4 minutes, the control will shut off and the settings will be lost.
AUTO SOAK
Use the AUTO SOAK option to presoak garments to help remove difficult spots or stains on fabrics.
This option provides a 30 minute presoak prior to the start of the selected cycle.
1. Add detergent only to the Main wash compartment or Liquid Box of the dispenser drawer.
2. Select desired cycle.
3. Select cycle modifiers
4. Press the START/PAUSE.
2
nd
RINSE
This option will add an extra rinse to the selected cycle. Use this option to help ensure the removal of
detergent or bleach residue from fabrics.
CLEAN WASHER
A buildup of detergent residue can occur in the wash tub over time and can lead to a mildewy or musty smell.
The CLEAN WASHER cycle is specially designed to remove this buildup using bleach or other cleaner
designed specifically for cleaning front load washers.
The CLEAN WASHER cycle should be run once a month, or more often under heavy use conditions or if
odor is present.
For powdered tub cleaners, add the cleaner to the main wash compartment of the dispenser drawer. Place
tablet cleaners directly into the tub. Always follow the cleaner manufacturers instructions and
Recommendations
NOTE: Do NOT use this cycle with clothes, and do NOT add detergent or fabric softener.
MY CYCLE
SMART SENSE
CONTROL LOCK
Use this option to disable the controls. The washer can be locked during a cycle. This feature allows you to
prevent children from changing cycles or operating the machine. Once set, the CONTROL LOCK must be
turned off before the controls can be used. Once the washer has shut off, the power button will allow the
machine to be turned on, but the controls will still be locked. When the controls are locked, "CL" will be
displayed alternately with the estimated time remaining. Press and hold the CONTROL LOCK button for
5 seconds to activate or deactivate the controls.
Select this option to store a customized wash cycle for future use.
1. Select a cycle.
2. Press the desired options.
3. Press the desired modifiers.
4. To save the cycle press MY CYCLE for 3 seconds.
5. Press the START/PAUSE.
6. To reuse this cycle at another time, select MY CYCLE and press the START/PAUSE
This feature uses a sensor in the tub to check the hardness of the water and the detergent amount. Wash and
rinse cycles will be adjusted to optimize wash and rinse performance.
To use the SMART SENSE feature press and hold 2nd RINSE button for 3 seconds.
Excessive detergent amount: rinsing cycle increase.
Insufficient detergent amount: washing time increase.
A small amount of remaining detergent detected: additional rinsing will be added.
5-4. SPECIAL FUNCTION