4. DISPENSER
- 71 -
2) Remove the Display Frame moving out with both hands
in one side and make the same process in the other side
and pulling it forward like shows the picture.
3) The Display Assembly can be connected by pressing the
top of the Dispenser Cover and pushing it after separating
the Display Frame from its housing.
1) Disconnect funnel and button assembly by pulling down
and forward.
4) Loosen four screws with a phillips screwdriver and pull
the funnel assembly to disconnect.
5) The Cap Duct Assembly can be disconnected if the hold
lever connecting screw is loosened with a phillips driver.
6) To install the Cap Duct Assembly, insert one end of the
spring into the right hole of the dispenser lever and insert
the other end into the right hole in the top part of the
dispenser. Then attach the holder at the solenoid switch.
