29
Problem
Possible Cause
Solutions
Yellow or brown film
on inside surfaces of
dishwasher.
Coffee or tea stains.
•
Eliminate the stain by using a stain removal
product.
Dishes don’t dry.
Rinse agent dispenser empty.
•
Check and refill the rinse agent dispenser if
empty.
Lamps do not illuminate.
Power is not connected.
•
Connect power supply.
Spray arms do not rotate
smoothly.
Holes of spray arms are blocked by
food particles.
•
Clean the holes of spray arms.
Top rack is crooked.
Rack is poorly adjusted.
•
See the Height Adjustable Top Rack section.
Dishwasher continuously
beeps when the door is
opened, during or right after
a cycle has completed.
The contents of the dishwasher are hot
and care should be used when placing
your hands inside the dishwasher.
•
Close the door until the dishwasher and
dishes have cooled down. The beeping will
stop if the door is closed or the interior
temperature has cooled.
Dishwasher chimes if panel
is touched during operation.
Bumping into or touching the control
panel during operation may result in a
disabled button sound. Only the Power,
Start, and Control Lock buttons are
enabled during operation to prevent
cycle settings from being changed
inadvertently.
•
Button sounds can be turned off by pressing
and holding Mixed Load and Eco Wash for
three seconds.
•
The end of cycle chime and safety alert
sounds will still sound.
Dishwasher did not finish
cycle.
Door was opened during cycle.
•
If the door is opened during a cycle, the Start
key must be pressed within 4 minutes or the
machine turns off and all settings are lost.
Leaking in front of unit
Dishwasher not leveled properly.
•
Verify the unit is level from side to side and
from front to back. See leveling instructions
in the Installation section.
Wrong detergent used.
•
If excessive sudsing is causing the leak,
allow the foam to subside for 24 hours then
clean the inside of the tub with milk.
n:#, U:#, d:#, t# appears in
display.
(# = a number)
Test mode is selected.
•
This is not an error code. This code is used
when testing the dishwasher. Power the unit
off and on and the code will disappear.
L0, L1, L2, L3 or L4 appears
in display.
Rinse Aid Level setting mode is selected.
•
This is not an error code. This code indicates
the current rinse aid level. For more
information, refer to the Detergent and
Rinse-aid section.
CL appears in display.
Control Lock is activated.
•
This is not an error code. This code
indicates that the control lock is activated.
Press and hold Half Rack and Eco Wash
simultaneously for three seconds.
