15
†A small amount of water is run through the pump to
remove soil particles between the main wash and final
rinse.
*
If the incoming water temperature is less than the
recommended temperature or food soils are heavy, the
cycle will automatically compensate by adding time,
heat, and water as needed.
**Hard water is defined as 7 grains per U.S. gallon and
above.
NOTE:
The sensor in your dishwasher monitors the soil
level. Cycle time and/or water usage can vary from the
numbers above as the sensor adjusts the cycle for the
best wash performance.
Canceling a Cycle
1.
Press CANCEL/DRAIN. The Cancel/Drain light glows.
2.
The dishwasher starts a 2-minute drain (if needed). Let
the dishwasher drain completely. The light turns off
after 2 minutes. The door must be closed for the
dishwasher to drain.
To stop the drain
You can press CANCEL/DRAIN again to stop the drain. Be
sure to drain the dishwasher before starting a new cycle.
To clear the indicators
Press CANCEL/DRAIN before starting the dishwasher to
clear all options and cycles.
Changing a Cycle or Setting
During the first minute of a cycle
1.
Select a new cycle and/or options.
2.
Check the detergent dispensers. They must be filled
properly for the new cycle.
3.
The Start/Resume light will flash when the door is
opened. Make sure the door is closed.
4.
Press START/RESUME.
After the first minute of a cycle
1.
Press CANCEL/DRAIN. The Cancel/Drain light glows.
Your dishwasher starts a 2-minute drain (if needed). Let
the dishwasher drain completely.
2.
Check the detergent dispensers. They must be filled
properly for the new cycle.
3.
Make sure the door is closed. The Start/Resume light
will flash.
4.
Select a new cycle and/or options.
5.
Press START/RESUME.
Adding Items During a Cycle
You can add an item anytime before the main wash starts.
Open the door and check the detergent dispenser. If the
cover is still closed, you can add items.
To add items
1.
Open the door slightly to stop the cycle. Wait for the
spraying action to stop before opening the door. The
Start/Resume light will flash.
2.
Open the door. If the detergent dispenser cover is still
closed, add the item.
3.
Close the door firmly until it latches. The Start/Resume
light will flash.
4.
Press START/RESUME.
IMPORTANT:
If Lock On is selected, turn off the lock (see
Lock On section in “Option Selections”), or the Start/
Resume light will continue to flash.
Option Selections
You can customize your cycles by pressing an option. If
you change your mind, press the option again to turn the
option off, or select a different option if desired.
You can change an option anytime before the selected
option begins. For example, you can press an unheated
drying option anytime before drying begins.
Press START/RESUME to use the same cycle and
option(s) as the previous wash cycle.
NOTE:
If the last cycle you completed was a rinse cycle,
when you press START/RESUME, the dishwasher runs the
last full wash cycle and options.
High Temp
Select this option to increase the water temperature during
the wash portions of the cycle. High Temp raises the water
temperature to 145ºF (63ºC), in the main wash. Heating the
water helps improve washing results. High Temp is useful
when loads contain tough food soil.
This option may add heat and wash time to the cycle.
NOTE:
High Temp is an option with the SMART WASH™,
Pots Pans, and Normal Wash cycles.
Sani Rinse
Select this option to raise the water temperature in the final
rinse to approximately 155°F (68°C). Sani Rinse adds heat
and time to the cycle. This high temperature rinse sanitizes
your dishes and glassware in accordance with NSF/ANSI
Standard 184 for Residential Dishwashers. Certified
residential dishwashers are not intended for licensed food
establishments.
NOTE:
Sani Rinse is an option with SMART WASH™, Pots
Pans, and Normal Wash cycles. Only these sanitization
cycles have been designed to meet the NSF/ANSI
requirements.
Quick Rinse
Use this rinse cycle for rinsing dishes, glasses, and
silverware that will not be washed right away.
Do not use detergent with this cycle.
Wash
Main
Wash
Rinse
or
Purge
Final
Rinse
Dry
Time
(min)
Water
Usage
(gal/L)
●
Rinse
10
1.8-2.2/
6.8-8.3
