10
The unit should now be ready to slide into the cabinet
opening. To avoid scratching the loor, use loor protection
and caution when sliding the dishwasher into the cabinet.
Make sure that the hoses and cords do not bunch up behind
the unit or kink as you slide the unit back. Make certain to
slide the unit into place before raising the leg levelers.
NOTE: If the dishwasher is not level, it may not operate
properly and could cause leaks.
Check that the leveling legs are irmly against the loor.
• Place a level against the front panel.
• Check that the dishwasher is plumb. If needed, adjust
leg levelers until dishwasher is plumb.
• Open the door.
• Place the level inside against the top of the tub.
• Check that dishwasher is level from side to side. Adjust
the leg levelers as necessary.
Adjusting the leg levelers:
• To adjust the front feet (X), turn
clockwise to raise
or
counter-clockwise to lower
.
• To adjust the back foot, turn the center screw (Y)
clockwise to raise
or
counter-clockwise to lower.
For Top Mount - Wooden
For Side Mount - Stone Countertop
0-
2.
5
“
mm/
0.5
”
mm/ 0.1”
mm/
0.
1”
mm/ 0.5”
LEVELING THE DISHWASHER
SECURING THE DISHWASHER
1. Drive the mounting screws through the holes in the
mounting brackets as shown for Top or Side Mount.
2. After the unit is installed in the enclosure, leveled and
secured, lock the two front leg levelers in place by
driving the enclosed leg leveler locking screws into each
screw slot located in front of the levelers.
3. Tighten screws until they are lush with the surface of the
slots.
Y
X
Summary of Contents for 630.1300 Series
Page 22: ......
