Kenmore 587.1468*, Use & Care Manual

Page: 11 / 28

11
Care & Cleaning
Allow heating element to cool
before cleaning the interior.
Failure to do so can result in burns.
Burn Hazard
Care of Drain Air Gap
If a drain air gap was installed for your built-in
dishwasher, check to make sure it is clean so the
dishwasher will drain properly. A drain air gap is usually
mounted on countertop and can be inspected by removing
the cover. This is not part of your dishwasher and is not
covered by warranty.
Outside
—
Occasionally wipe with a mild nonabrasive
detergent and water. Rinse and dry.
Inside
—
The inside of the dishwasher is self-cleaning with
normal use.
To clean Stainless Steel wipe with the grain.
NEVER
use the products that contain Chlorine Bleach
or Citric Acid.
Important: The dishwasher motor is permanently
lubricated at the factory and does not need to be oiled.
TTTTTo Disconnect Ser o Disconnect Ser o Disconnect Ser o Disconnect Ser o Disconnect Service: vice: vice: vice: vice:
1. Turn off electrical power to the dishwasher at the
supply source by removing fuses or tripping circuit
breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve. Disconnect water
line from inlet valve and drain into pan.
4. Disconnect drain line from pump and drain water into
pan.
TTTTTo Restore Ser o Restore Ser o Restore Ser o Restore Ser o Restore Service: vice: vice: vice: vice:
1. Reconnect the water, drain, and electrical power
supply.
2. Turn on water and electrical power supply.
3. Fill both detergent cups and run dishwasher through a
NORMAL WASH Cycle.
4. Check connections to make sure they do not leak.
A dishwasher left in an unheated place should be
protected from freezing. Have a qualified person
do the following:
Winterizing
Note: Note:
Note: Note: Note:
See Installation Instructions for more details on
disconnecting and restoring service to your dishwasher.
Note: Note: Note: Note: Note:
See Installation Instructions for more details on
disconnecting and restoring service to your dishwasher.