Kenmore 587.1400 Series, Use & Care Manual

Page: 9 / 13

9
Dishwasher Dispenser Dishwasher Dispenser
Dishwasher Dispenser Dishwasher Dispenser Dishwasher Dispenser
& Deter & Deter
& Deter & Deter
& Detergents gents
gents gents
gents
(continued) (continued)
(continued) (continued) (continued)
Rinse Aid Rinse Aid Rinse Aid Rinse Aid Rinse Aid
Rinse aid greatly improves drying and reduces
water spots and filming.
Water “sheets” off
dishes rather than forming water droplets that
cling and leave spots.
A dispenser, located next to the detergent cup,
automatically releases a measured amount of
rinse aid during the last rinse. If spotting and poor
drying are problems, increase the amount of rinse
aid dispensed by rotating the dial to a higher
number. The dial is located under the dispenser
cap. The indicator will be dark when full and will
show clear when it is time to refill.
To add liquid rinse aid, turn dispenser cap 1/4 turn
counterclockwise and lift out. Pour in rinse aid until
liquid touches the indicated fill level. Replace cap.
Do not overfill since this can cause oversudsing.
Wipe up any spills with a damp cloth.
The dispenser holds enough for 35 to 140 washes,
depending on setting.
Adjustable setting
Factors Af Factors Af
Factors Af Factors Af
Factors Affecting fecting
fecting fecting
fecting
Per Per
Per Per Perfor
for
for for formance
mance
mance mance mance
W W
W W Water Pr
ater Pr
ater Pr ater Pr ater Pressur
essur
essur essur essure
e
e e e
The hot water line to the dishwasher must provide
water pressure between 20 and 120 psi.
Low water pressure may occur when laundry or
showers are in operation. Wait until water use is
reduced before starting dishwasher.
W W W W Water T ater T ater T ater T ater Temperatur emperatur emperatur emperatur emperature e e e e
Hot water is needed for best dishwashing and
drying results. Water entering dishwasher should
be at least 120°F (49°C) to give satisfactory
results.
To check water temperature entering dishwasher:
•
Turn on hot water faucet nearest dishwasher
for several minutes to clear cool water from
pipes.
• Hold a candy or meat thermometer in stream
of water to check the temperature.
• If temperature is below 120°F (49°C), have a
qualified person raise the hot water heater
thermostat setting.
Important: Before starting a cycle, run hot
water through faucet to clear cool water from
pipe.
Dispenser Opening Indicator
Dispenser Cap
ENGLISHENGLISHENGLISHENGLISHENGLISH