W ater Level
There is no need to select a water level. The
washer automatically adjusts the water level to the
type and size of wash load.
Cycle Options
To select Heavy Soil/Stain, Auto Temp, Extra Spin
and Extra Rinse, press OPTIONS until flashing
light
indicates
desired
option.
Then press SELECT
to add that option to the cycle. To delete an indi-
cated option, press SELECT.
Heavy Soil / Stain
Use this option to add approximately 6 minutes of
wash time to very soiled or stained loads.
Auto Te m p
The temperature of warm and cold wash water
can be affected by the water heater setting and
seasonally low ground water temperatures in some
geographic areas. Since detergents work best in
wash water at a minimum of 65° F, select A U TO
TEMP to regulate the temperature of warm wash
to approximately 100° F and cold wash to approxi-
mately 70° F. Rinse water temperatures are not
regulated.
Extra Rinse
Use this option when additional rinsing is desired
to remove excess dirt and detergent. It is recom-
mended for heavily soiled loads or if household
members have sensitive skin. Extra Rinse occurs
before the liquid fabric softner is dispensed.
Extra Spin
Use this option for several additional minutes of
spin at the selected spin speed. This will increase
water extraction and decrease drying time.
W asher Features
Control Lock
To prevent accidental operation of the washer or
alteration of the cycle settings, press and hold the
lock symbol until you hear 3 beeps and “LOC” is
displayed. To cancel, press and hold the lock sym-
bol until “LOC” is no longer displayed.
Signal
A signal will sound at the end of the cycle. Re-
peatedly press the signal symbol to select one of
three volume levels or turn off the signal. The
selection will be programmed until you change it.
Delay
This feature allows you to delay the beginning of a
cycle to an off-peak energy hour or a time more
convenient to your personal schedule. Press
DELAY for each one-hour increment, up to 12
hours.
The hours remaining until the cycle begins
will be displayed.
Display
The following will be displayed during the cycle:
·
Estimated Remaining Cycle Time
·
Door Lock
·
Cycle Status (W ASH, RINSE, FINAL
SPIN)
.
·
Signal volume selected
·
“LOC” will be displayed briefly when lock
symbol is pressed.
·
Hourly countdown will be displayed when
DELAY is pressed.
Error Codes
If the washer stops and the F1,F3, F4 or F5 error
code is flashing in the display, press STOP/CLEAR,
select a cycle and press STA RT. If the error code
appears again, please contact service for assis-
tance.
F1 There may be an internal problem with
the wash system.
F2 There may be a water temperature prob-
lem. Be sure hot and cold water hoses
are properly connected before calling service.
F3 Be sure the water is turned on before calling
service. There may be a problem with the
pump or pressure switch.
F4 The washer may have run too long or there
may be a problem with the motor control.
F5 There may be a problem with the keypad.
PN 134236700 (0307)
Page 3
Summary of Contents for 44072
Page 5: ......