28
Self-Clean Cycle Time Length
The
pad controls the Self-Cleaning feature. When used with a the
pad, a delayed Self-Cleaning cycle may also be programmed. The Flex Clean
feature allows for any Self-Cleaning cycle time from 2 (2:00) to 4 hours (4:00).
You may also choose the clean time in 1 minute increments (for example 2 hours
and 50 minutes) by pressing the number keypads
2 5 0
.
If you are planning to use the oven directly after a self-clean cycle remember to
allow time for the oven to cool down and the oven door to unlock. This normally
takes about one hour. So a 3 hour self-clean cycle will actually take about 4 hours
to complete.
*
It is recommend to use a 2 hour self-clean cycle for
light soils
, a 3 hour cycle for
average soils
, and a 4 hour cycle for
heavy soils
(to assure satisfactory results).
CAUTION
To avoid possible burns
use care when opening the oven door
after the Self-Cleaning cycle. Stand
to the side of the oven when opening
the door to allow hot air or steam to
escape.
CAUTION
DO NOT
force the
oven door open. This can damage
the automatic door locking system.
Use caution and avoid possible burns
when opening the door after the Self-
Cleaning cycle has completed. The
oven may still be VERY HOT.
To start an immediate Self-Cleaning cycle or to set a Delay
Start time of 9:00 o’clock and shut-off automatically (example
provided is a default 3 hour Self-Clean cycle)
1. Be sure the clock is set with the correct time of day, the oven is
EMPTY and the oven door is closed.
2. Press
. "
CLEAN
" will flash and "
3:00
"
HR
will show in the
display (Fig. 1). The control will automatically clean for a 3 hour
period (default self-cleaning cycle time). Note: If a 2 or 4 hour
clean time is desired, press
2 0 0
for 2 hour or press
4 0 0
for a
4 hour clean time. Set the cleaning time based on the amount of
soil: light, medium or heavy (* See above).
3. Press
. The "
DOOR LOCKED
" icon will flash.
4. The motor driven oven door lock will begin to close automatically.
Once the door has been locked the "
DOOR LOCKED"
indicator
light will stop flashing and remain on (Fig. 3).
Note: Allow about 15 seconds for the oven door lock to close.
Note: If the optional delay Self-Clean feature is needed, finish steps
5-7. If Self-Clean is started immediately skip the remaining steps and
continue with "When the Self-Clean cycle is done" on the following
page.
5. Press
(Fig. 4). Enter the desired Self-Clean starting time
using the number pads
9 0 0
(Fig. 5).
6. Press
. "
DELAY
", "
DOOR LOCKED
", "
CLEAN
" and Cooktop
locked icons will remain on.
7. The control will calculate forward from the set start time to
determine when the Self-Cleaning cycle should end. The Self-
Cleaning cycle will turn on automatically at the set time. At that
time the icon "
DELAY
" will go out; the oven icon will come on, the
start time, "
CLEAN
" and "CLn" will remain in the display (Fig. 6)
2 0 0
or
4 0 0
9 0 0
Self Cleaning
INSTRUCTIONS
PRESS
DISPLAY
Fig. 5
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 6
