7
6
OPERATING INSTRUCTIONS
Always operate the heater in the upright position following all instructions and
recommendations listed in this manual.
HEATER LOCATION
Place the heater in the area of the room that is coldest.
HEATER CONNECTION
outlet. A loose connection may cause overheating and damage to the plug or heater.
NOTE: To prevent overloading a circuit, do not plug the heater into a circuit that
is servicing other electrical needs.
HEATER OPERATION
OPERATING INSTRUCTIONS
OSCILLATING FUNCTION
The Oscillating function will work in any mode.
1. Press the
button to oscillate the heater fan from left to right across a 90
degree arc. The indicator symbol
will display on the heater control panel.
button again.
The Timer function will work in any mode. The Timer function allows you to set the
length of operation from 1 to 8 hours. Each time the button is pressed the length
of operation will increase 1 hour. The duration the timer is set for will be displayed
on the LED screen in hour increments. TO TURN THE TIMER FUNCTION
the
E
TIMER FUNCTION
1.
may
the desired temperature setting in any heater operation mode.
The temperature can be set from
to
2. Press the or button to
the temperature setting.
The heater will operate in
HEAT mode and blow warm air when the set
temperature is
higher than the room temperature.
The heater will operate in HIGH HEAT mode and blow hot air when the set
temperature is more than
higher than the room temperature.
When the room temperature reaches the set temperature the heater will
automatically go into FAN
and blow unheated air.
The heater will cycle between FAN
and
HEAT
as it
maintains the set temperature.
TEMPERATURE SETTING
The heater must cool down and be reset before it will
On. Press the (l) button on the control panel to resume normal operation. sure that
the heater is on a
surface with no obstructions. The heater is also
ped with a safety
switch to turn power o
ff
to the heater when the
heater tips
To resume heater functions simply stand heater upright. With tip
protection, the heater will only operate when placed upright on a
surface.
SAFETY FEATURES
REMOTE CONTROL
The remote control uses one button cell battery, type
the remote. See Fig. 4. We recommend the use of a
battery for longer
use.
Follow battery disposal instruction on battery
, or contact your
local safety council for safely disposal of batteries.
using the remote
Fig. 4
control, you must
the insulating
fil
m as shown
in the
figur
e below.
1. All functions performed
identically to the heater
control panel.
Aim the remote control at
the heater control panel to operate the heater.
The heater may be operated by the controls located on the heater (see Fig. ) or by
the remote control (see Fig. .
1. Carefully remove the heater/fan from the plastic bag and the carton.
surface.
3. Power On the unit by switching on the
Power Switch (Fig.1). The control
then show the current room temperature.
.
automatically whe
n sufficiently cooled dow
n.
4. Turn the heater ON by pressing the button on the control panel or remote
control.
5
6
.
Regardless of the difference between room temperature and heater setting, yo
u
HIGH or FAN mode.
PULL
Remote control
Insulating film
Battery carriage
Release Tab