9
Laundry tub drain or standpipe drain
Connecting the drain hose form to the corrugated
drain hose
To keep drain water from going back into the washer:
■
Do not force excess drain hose into standpipe. Hose should
be secure but loose enough to provide a gap for air.
■
Do not lay excess hose on the bottom of the laundry tub.
Floor drain
Do not install the drain hose form on to the corrugated drain
hose. You may need additional parts. See Floor drain under
“Tools and Parts.”
Connect the Inlet Hoses
1.
Insert new flat washers (supplied) into each end of the inlet
hoses. Firmly seat the washers in the couplings.
Connect the inlet hoses to the water faucets
Make sure the washer basket is empty.
2.
Attach the hose labeled hot to the hot water faucet. Screw
on coupling by hand until it is seated on the washer.
3.
Attach the hose labeled cold to the cold water faucet. Screw
on coupling by hand until it is seated on the washer.
4.
Using pliers, tighten the couplings with an additional
two-thirds turn.
NOTE:
Do not overtighten or use tape or sealants on the
valve. Damage to the valves can result.
Clear the water lines
■
Run water through both faucets and inlet hoses, into a
laundry tub, drainpipe or bucket, to get rid of particles in the
water lines that might clog the inlet valve screens.
■
Check the temperature of the water to make sure that the hot
water hose is connected to the hot water faucet and that the
cold water hose is connected to the cold water faucet.
Connect the inlet hoses to the washer
1.
Attach the hot water hose to the inlet valve labeled hot.
2.
Attaching one hose coupling first makes it easier to tighten
the connection with pliers.
3.
Screw on coupling by hand until it is seated on the washer.
A
B
A. Feed end of drain hose into one end of form. Secure the lip of the
form into one of the hose ribs.
B. Bend the hose over the top of the form and feed into the other end
of the form. Secure the lip of form into one of the hose ribs.
A. Coupling
B. Washer
A
B
Tighten the couplings with an additional two-thirds turn.
A. Hot water inlet valve
B. Cold water inlet valve
HOT COLD
A
B
COLD
HOT
