7
10. ATTACHING THE LED
LIGHT KIT
NOTE:
Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box. Turning power
off using the fan switch is not sufficient to
prevent electric shock.
Step 1. Remove one of the three light kit
mounting screws from the mounting ring and
loosen the other two screws. (Do not remove.)
Step 2. While holding the 18W LED light kit
under the fan motor assembly, make the 2-pin
wire connections:
- White to white
- Black to black
Step 3. Place the key holes in the LED light kit
over the two mounting screws previously
loosened from the mounting ring. Turn the
light kit until the light kit locks in place at the
narrow section of the key holes. Secure by
tightening the two light kit mounting screws
previously loosened and the one previously
removed. (Fig. 15)
9. ATTACHING THE FAN
BLADES
Step 1. Insert the blade through the slot on the
motor housing. Align the holes in blade and
blade bracket, place the blade support plate
on blade as showing in Figure 14, making sure
the holes are also aligned and secure with
fiber washers and screws provided.
Step 2. Repeat this procedure for remaining
blades.
CAUTION:
Make sure all screws are
tightened securely.
Figure 14
Figure 15
Blade
Slots
Blade support
plate
Screws and
fiber washers
Mounting ring
Screws
LED Light kit
Wire connectors
