Kendal Lighting AC-21560, Installation And Operation Manual

Page: 3 / 9

OUTLET BOX
RECEIVER
RED WIRE
PURPLE WIRE
GREY WIRE
BLUE WIRE
WHITE WIRE
GREEN WIRE
1. Securely attach the hanger bracket to the outlet box
by washers and screws suppplied. Connect white
wire from ceiling to white wire from receiver with
wire nut. Connect black wire from ceiling to
black wire from receiver with wire nut. (see Fig.3)
2. Carefully lift the fan and seat the down rod ball
assembly on the hanger bracket. Be sure the
groove in the ball is lined up with tab on the
hanger bracket . Do not pinch wires between the
ball and down rod assembly and hanger bracket
(see Fig.4)
3. Install the safety cable into the building structure.
(see Fig.6)
Putting Your Fan Together
Hanging Your Ceiling Fan
1. Remove the hairpin clip & washer from the clevis
pin and remove clevis pin from down rod. (see
Fig.1)
2. Insert the down rod through the center opening in
the canopy,coupling cover and route the motor
leads through the hanger ball/downrod assembly.
Align the clevis pin holes in the downrod with the
holes in the motor coupling. The clevis pin must
pass through the holes in the motor coupling and
the downrod. Place the washer onto the clevis pin
and install the hairpin clip making sure to push
straight leg of the hairpin clip through the hole
near hanger ball to make sure the clevis pin is
properly installed(see Fig.2)
3. Reinstall the 2 set screws in the motor coupling and
securely tighten set screws against the down rod
assembly.
HANGER
BRACKET
FAN
COUPLING COVER