8
11. ATTACHING THE
LIGHT KIT PLATE
NOTE:
Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box. Turning power
off using the fan switch is not sufficient to
prevent electric shock.
Figure 17
Figure 18
Figure 19
12. ATTACHING THE
LIGHT BULBS AND
GLASS SHADE
Step 1. Install 1 × 75W halogen bulb
(included). (Fig. 18)
Step 2. Install the glass shade by carefully
turning it clockwise until snug.
DO NOT
OVERTIGHTEN.
(Fig. 19)
Screw
Outer glass shade
Inner glass shade
Bulb
Mounting plate
Mounting plate
Light kit plate
Black wire
connectors
White wire
connectors
Remove 1 of 3 screws from the mounting plate
and loosened the other 2 screws(Do not
remove). (Fig 17)
Connect white wire from motor to white wire
from light kit plate. Connect black wire from
motor to black wire from light kit plate.
Place key holes on the light kit plate over the 2
serews previously loosened from the
mounting plate, turn light kit plate until it locks
in place at the narrow setion of the key
holes.Secure by tightening 2 screws
previously loosened and the one previously
removed. (Fig 17)
WARNING:
Shut off the power supply before
removing or replacing lamp. In handling of
halogen bulb, care should be taken not to touch
it with your bare hands. Oil residue will shorten
the life of the halogen bulb. If you accidentally
come into contact, wipe thoroughly with a clean,
lint-free, cotton cloth before installing. Allow the
bulb to cool off before changing the bulb. Use
light bulb in accordance with the fan's specifica-
tion.
REDUCE THE RISK OF FIRE DO NOT
EXCEED MAXIMUM WATTAGE RATING.
