7
10. INSTALLATING THE
MOUNTING PLATE
Step 1. Remove the 1 of 3 screws from the
mounting ring and loosen the other 2 screws.
(Do not remove)
Step 2. Place the key holes on the mounting
plate over the 2 screws previously loosened
from the mounting ring, turn mounting plate
until it locks in place at the narrow section of
the key holes. Secure by tightening the 2
screws previously loosened and the one
previously removed. (Fig. 16)
Figure 15
Figure 16
9. ATTACHING THE FAN
BLADES
Figure 13
Figure 14
Screws
Screws
Paper washers
Blade
Mounting
plate
Mounting ring
Screws
Blade holder
CAUTION:
Make sure all screws are
tightened securely.
Step 1. Attach the fan blades to the blade holders
by using three screws and paper washers as
shown in Figure 13. Start a screw into the blade
holder, do not tighten. Repeat for the 2 remaining
screws and washers.
Step 2. Tighten each screw securely starting with
the center screw. Make sure the blade is straight.
Step3. Remove the screws from the bottom
motor before fasten the blade assemblies to the
bottom motor housing.
Step 4. Tighten the blade assemblies onto
bottom motor by using two screws reviously
removed from the motor.(Figure 14)
The following procedure should correct most fan
wobble. Check after each step.
Step 1. Check that all blades and blade holder
screws are secure.
Step 2. Most fan wobble problems are caused
when blade levels are unequal. Check this level
by selecting a point on the ceiling above the tip of
one of the blades. Measure this distance as
shown in Figure 16. Rotate the fan until the next
blade is positioned for measurement. Repeat for
each blade. The distance should be equal within
1/8".
Motor
Blade assembly
Touching ceiling
