When you see this image, you will know the Kenall product shown or described is designed and manufactured in the USA with components purchased from US suppliers, and meets the Buy
American requirements under the ARRA. Kenall has not determined the origin of its domestically purchased components or the subcomponents thereof. May be covered by patents found
at www.kenall.com/patents. Content of specification sheets is subject to change; please consult www.kenall.com for current product details. © 2015 Kenall Mfg. Co. All rights reserved.
www.kenall.com
P: 800-4-Kenall F: 262-891-9701 10200 55th Street Kenosha, Wisconsin 53144
2
INSTALLATION INSTRUCTIONS
F-4260_091118
1:
Remove tertiary lens (if provided) by unscrewing (4) captive screws.
2:
Remove heatsinking/LED base by unscrewing (4) captive screws.
These will be the inner most screws.
3:
Disconnect the quick connector wires from the LED board and
the driver.
4:
Make electrical connection to J-box (for sizes, see next page). Circuit
wire connection must be in J-box. Install housing to surface using (4)
5/16" diameter mounting holes.
5:
Re-assemble by reversing the removal procedure.
DRIVER
QUICK CONNECT
HEATSINK/LED BASE
CAPTIVE SCREWS (4)
FOR REMOVING HEATSINK
CAPTIVE SCREWS (4)
TERTIARY LENS (IF PROVIDED)
HOUSING
HOUSING TOP VIEW
5/16” MOUNTING HOLES (4)
DIRECT TO SURFACE INSTALLATION
