background image

www.kenall.com  |  P: 800-4-Kenall  |  F: 262-891-9701  |  10200 55th Street Kenosha, Wisconsin 53144, USA         

This product complies with the Buy American Act: manufactured in the United States with more than 50% of the component cost of US origin. It may be covered by patents 
found at www.kenall.com/patents. Content of specification sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co. 

6

INSTALLATION INSTRUCTIONS

MAC_F-1785_090418

YOKE INSTALLATION

1.  After carriage bolts have been set to proper height dimensions, and center points have been located in ceiling 

supports, attach yoke assembly (yoke/support attach hardware by others.

2.  Refer to the chart below and locate the appropriate “A” dimension. This dimension is the amount of the 

threaded bolt required to secure the fixture.

WIRING INSTRUCTIONS

1.  Read all fixture markings and labels to insure correct installation of the fixture. Additional information may be 

located on the fixture, separate from this instruction sheet, regarding orientation and mounting restrictions.

2.  Disconnect power to main circuits before wiring fixture.
3.  Undo center reflector and wire way cover to gain access to the inside of the fixture (also refer to next page for 

diffuser operation).

4.  Attach conduit to wiring hole.
5.  Connect fixture leads to power supply leads using connectors suitable for the gage and number of wires being 

used (not included). Connections are to be made in the junction box, not the fixture. Black and other colored 
wires connect to the supply conductor, white fixture lead connects to the neutral supply conductor, and the 
grounding wire must be connected to a suitable ground.

6.  Fasten wire way cover and center reflector.

Summary of Contents for Medmaster MAC Series








Reviews: