www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United State swith more than 50% of the component cost of US origin It may be covered by patents
found at www.kenall.com/patents. Content of specification sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co.
1
INSTALLATION INSTRUCTIONS
LTS1830_F-5473_091118
Luminaires for Tunnel Applications
LUXTRAN
™
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed, including the following:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND
THE HAZARDS INVOLVED. CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION
PERTINENT, PAR UNE PERSONNE QUI CONNAÎT BIEN LE PRODUIT ET SON FONCTIONNEMENT
AINSI QUE LES RISQUES INHÉRENTS. DISCONNECT POWER TO ALL CIRCUITS BEFORE WIRING FIXTURE. INSTALL IN
ACCORDANCE WITH ALL NATIONAL, STATE, AND LOCAL CODES. DO NOT CONNECT TO AN UNGROUNDED SUPPLY. READ ALL
FIXTURE MARKINGS AND LABELS TO ENSURE CORRECT INSTALLATION OF FIXTURE. SUPPLEMENTAL INSTRUCTIONS MAY BE
LOCATED ON THE FIXTURE, IN ADDITION TO THIS INSTRUCTION SHEET, REGARDING ORIENTATION, OR MOUNTING RESTRICTIONS.
SAVE THESE INSTRUCTIONS
LTS1830 SERIES
1. After removing existing wireway gasket and cleaning surface, install provided gasket and seal joints with RTV.
2. Wire provided socket assemblies to existing 277VAC input wiring. Each 8’ wireway segment will have either (1)
or (2) fixtures attached.
Black- 277VAC input
White- Neutral
Green- Ground
3. Note label on extruded aluminum wireway cover showing direction of Type 2 light distribution and align cover
appropriately. Connect green ground wire from cover to ground connection in wireway.
4. Feed sockets through holes in cover.
5. Place support straps over wireway 33” from each end. Attaching the supplied brackets and rotating latches to
secure the cover. See Figure 1.
Figure 1
For segment with two fixtures
For segment with one fixture
For segment with two fixtures
