Kemppi Zeta G200 Operating Instructions Manual Download Page 4

Page: 4 / 9

4. Using helmet features

4.1 Taking into use

1. Adjust the helmet for your head:

A. Use the top bands to adjust how deep the

helmet sits (c).

B. Use the distance slide adjuster to change the

distance of the helmet from your face (b).
Ensure that the helmet is comfortably as close
as possible to your face and that both sides
are equally positioned.

C. Turn the knob in the rear to tighten and

secure the headband (a).

2. Turn the viewing angle adjuster to tilt the viewing

angle upwards or downwards. (d)

3. Adjust the helmet's opening/closing tightness if

needed (e).

4.2 Using work lights (G200x)

Zeta G200x helmet has LED work lights that are powered by
a rechargeable Li-ion battery unit on the neckband.

1. Press the battery test button on the battery unit to

check the battery level.

2. For charging, remove the battery unit from the

helmet and charge the battery using the unit's
USB-C connection and charging cable (charger not
delivered with the product).

3. Insert the battery unit into the battery holder in the

headband and connect the LED work light cable to it.

4. Use the OFF/AUTO/ON selector to turn the lights on

and off. The AUTO mode turns the lights off in bright
conditions (e.g. day light) and then back on.

Caution:

Never use a damaged battery unit.

The LED light battery unit is not waterproof.
Avoid exposure to extreme temperatures, direct
sunlight, moisture, sand and dust.
Observe the battery unit while charging. If the
battery unit becomes hot, smokes or there are
visible deformations in the battery unit during
charging, stop charging immediately.

5. Replacing parts

5.1 Removing headband

1. Press and hold down the distance slide adjuster (7).
2. Push the headband connector forwards, out of the

distance slide adjuster.

5.2 Attaching headband

1. Bring the headband connector in front of the dis-

tance slide adjuster (7).

2. Press down the slide adjuster button while pushing

the headband connector through the distance slide
adjuster.

3. Slide the headband connector in place so that the

slide adjuster pin locks into one of the grooves in the
headband connector.

4. Adjust the helmet distance from your face.

5.3 Replacing grinding visor

1. To remove the grinding visor: Release the helmet

fasteners by pulling the locking clips inwards and
pull out the grinding visor (a).

2. To install the grinding visor: Place the visor clips

into the helmet fasteners (b) and lock the helmet
fasteners by pressing them upwards (c). Ensure that
also the lower fasteners snap into place properly (d).

6. Maintenance

Inspect the helmet after each use. Replace worn or dam-
aged parts.

6.1 Cleaning

• Clean the grinding visor with mild soap, lukewarm

water and a soft cloth.

• Detach and wash the sweatband, if necessary.

7. Storage

Store the Zeta helmet in an environment with temperature
between -20...+50 °C and humidity < 80 % Rh.
Store and transport the helmet and the accessories in the
original bag or package.

ENGLISH