Owner’s manual
EN
10
Remote control
1. IR sensor
2. Speed + / - : press these buttons to increase/
decrease fan speed.
3. On button: press this button to turn on the
fan.
4. Mode button: press this button to switch
between modes: normal, sleep, natural.
5. Timer button: press this button to set the
time of device turn off.
6. Swing button: press this button to turn on/
off oscillation.
7. Off button: press this button to turn off the
fan
8. Battery cover
Battery installation
1. Open the battery cover.
2. Insert two 1,5 V AAA batteries with correct polarization (+/-).
3. Close the battery cover.
Notes:
•
Do not mix old and new batteries or batteries of different type.
•
Always point the IR sensor of the remote control towards control panel of the
fan.
Mounting
1. Assemble and connect the base with the pipe.
2.
Remove the Height adjustment knob from the Height adjustment pipe.
3.
Slide out the height adjustment pipe to the set the desired length and secure it
in place using height adjustment knob.
4. Loosen the fastening screw from the bottom of the motor unit holder then place
the unit on the inner pipe and tighten the screw to secure the holder to the pipe.
5. Fix the rear guard on the motor housing with rear guard screw.
6. Screw down the blade onto the fan axle with blade screw.
7. Fasten the front guard and rear guard with the clamping ring.
1
2
3
4
5
6
7
8
