7
Using the remote control
Replacing batteries
The following cases signify exhausted batteries.
Replace old batteries with new ones.
•
Receiving beep is not emitted when a signal is transmitted.
•
Indicator fades away.
The remote controller is powered by two dry batteries (2x AAA
1.5V)housed in the back rear part and protected by a cover.
1. Remove the cover in the rear part of the remote controller.
2. Remove the old batteries and insert the new batteries, placing
the(+) and (-) ends correctly.
3. Put the cover back on.
NOTE: When the batteries are removed, the remote controller
erases all programming. After inserting new batteries, the remote
controller must be reprogrammed.
warning
•
Do not mix old and new batteries or batteries of
different types.
•
Do not leave the batteries in the remote controller if they are
not going to be used for 2 or 3 months.
•
Do not dispose batteries as unsorted general waste. Collection
of such waste separately for special treatment
is necessary.
Indoor unit display
Digital display
•
Displays the temperature settings when the air conditioner is
operational.
•
Displays the room temperature in FAN mode.
•
Displays the self-diagnostic codes.
•
Displays ' ' for three seconds when Timer ON, Swing, Turbo
or Quiet feature is activated.
•
Displays ' ' for three seconds when Timer OFF is set.
•
Displays ' ' for three seconds when Swing, Turbo or Quiet
feature is cancelled.
•
Displays ' ' under defrosting operation.
•
Displays ' ' when anti-cold air feature is activated under
heating mode.
•
Displays ' ' during self clean operation (if applicable).
•
Displays ' ' under 8°C heating operation.
•
Displays ' ' when forced cooling mode is activated by pressing
•
If you want to turn off the indoor unit display (for example to
the manual start button 2 times within 5 seconds (refer page 16).
make the room dark for sleeping), press the LED button on the
remote control.
NOTE: For multi-split models, self clean operation will not
be available.