12
Installation – Electronics Testing
Before installation, the pre-assembled Electronics Kit
(e-Kit) must be tested:
Once plugged in, the fan should begin to spool up and the
LED display should show green, yellow, and red bars. Once the
front button blinks GREEN
(see figure 26 below)
, the electron-
ics kit has been successfully tested.
Note:
If it blinks blue or orange, swap the kit out for a differ-
ent one and mark the malfunctioning e-Kit for return to
Radiator Labs.
3.
Locate the three cables running from the e-Kit. The gray cable
is the radiator sensor, the white cable is the power cord, and
the four-pronged colorful cable is the Steam Trap Sensor.
1.
Connect all three cables to the correct cable that is affixed to
the radiator (for the sensors) and power brick (for the power
cable). The power cable must be connected last.
2.
Ensure the buttons do not stick when you push them.
4.
Fig. 26
After you connect
the cables and the
LED light bar starts
up, wait until you see
a green light blink,
indicating a
successful test
Cozy Installation Guide
Kelvin Systems, Inc.
