Assembly Update 045
CL2 Disc Change Procedure
Page 3 of 3
KEFM77-‐Assembly Update
Revision B
07/12/2016
Figure 3: CL2 disc with press jig in Closed position
Page 1: ...dure as follows 1 Locate press jig in press see Figure 2 for orientation 2 Load disc into press with Hook facing upwards ensure that Eye Clamp and Hook are secured within the jig with pins supplied 3 Close press applying force to Saddle see Figure 3 DO NOT exceed pressure of 9 Tonne 19 800lb 4 With the clamping force applied push or tap the shaft with a hammer drift and remove from the CL2 Disc as...
Page 2: ...with casting lugs 8 Close press and re apply clamping force Visually confirm that Hook location hole is properly aligned with Eye Clamp location hole 9 Locate pin within hole and tap gently through both castings 10 Remove clamping force and remove CL2 assembly from jig 11 CL2 disc is now ready for use Repeat procedure as necessary Figure 2 CL2 disc with press jig in Open position ...
Page 3: ... Assembly Update 045 CL2 Disc Change Procedure Page 3 of 3 KEFM77 Assembly Update Revision B 07 12 2016 Figure 3 CL2 disc with press jig in Closed position ...
