Page 10 of 14
RCA2610 Series Installation/Operation Guide
Rev
D
KELLY MANUFACTURING COMPANY
KMC
KMC
Publication No.1401-3
SECTION 4, GENERAL INFORMATION
4.1 Flight Testing and Adjustments
After flight testing and evaluation, additional calibration my be required depending on the user’s application. Communicate flight
test data with Kelly Manufacturing Company to determine appropriate adjustments.
4.2 Instrument Care
The most easily damaged part of your instrument is the screen. Special care should be taken when cleaning the screen to prevent
scratches and other damage. Avoid touching the screen at all times.
To clean light spots and dust, use a soft, lint free cotton cloth slightly moistened with distilled water.
You may also use cleaners approved for LCD TV’s and laptop computer screens.
Always apply the cleaner to the cloth and not the screen.
-CAUTION-
●
Do Not
use paper towels, facial tissue or napkins. These products are made from recycled paper and
may contain metals and wood chips that will scratch the screen.
●
Do Not
use acetone, alcohol or cleaners containing ammonia.
By avoiding all screen contact and by using proper cleaning methods, the user will be rewarded with many years of service.
4.3 OPTIONAL SLIP INDICATOR
An optional Slip/Skid Indicator (inclinometer) is available for the
RCA2610
(all models). The instrument can be purchased with
the Slip Indicator attached or purchased separately and installed by the user (part number 444-0010-01). The addition of a Slip
Indicator satisfies the requirements for FAA’s AC 91-75. The slip indicator may be attached before or after the instrument has been
installed in the aircraft.
INSTALLATION
1. Apply power to the instrument to assure that it reads level in pitch and roll.
2. Remove two screws on the face of the instrument.
3. Align slip indicator with holes and replace screws. Do not tighten.
4. Adjust the slip indicator until the bubble is centered and tighten screws just enough to secure Slip Indicator.
Do not over tighten.
SCREWS
SLIP INDICATOR
DIM
PITCH SYNC
Figure 4.1, Slip Indicator Installation
