KELLO-BILT 800 Series, Owner'S Manual, Page: 12 / 40

12
Transporting the Disc
□
Clean both quick disconnects and tractor couplers before connecting. Shut
off the tractor engine and move the hydraulic levers back and forth to
relieve pressure in the hydraulic system. Connect the hydraulics hoses to
the tractor hydraulic couplers. For ease of use it is recommended the
hoses be attached in the order which lowers the disc when the hydraulic
lever is pushed forward and raises it when the lever is pulled back.
□
CAUTION: Escaping fluid under pressure can penetrate the skin causing serious injury. Avoid this
hazard by relieving the pressure before disconnecting hydraulic or other lines. Tighten all the
connections before applying pressure. Search for leaks with a piece of cardboard. Protect hands and
body from high pressure fluids.
If an accident occurs, see a doctor immediately. Any fluid injected into the skin must be surgically
removed within a few hours or gangrene may result.
□ Turn jack handle to take weight off hitch jack. Unpin jack, remove pin, swing jack up into transport (i.e.
horizontal) position and re-pin.
□ If the tractor is equipped with a swinging drawbar. Make sure the drawbar is locked in the center
position.
□ Connect warning lights to the tractor outlet and make sure they are functioning properly. Make sure
the SMV sign is installed and visible from the rear of the machine.
□ Check tire pressure and adjust if necessary.
Transport Leveling Adjustment
.