3
CHECKS BEFORE COMMISSIONING A NEW MACHINE
Check and retighten all bolts, nuts and couplings, lubricate all
lubrication points, check the oil level in the tank and check that there
are no leaks in the hydraulic system before use.
INTRODUCTION
Thank you for choosing a product from Kellfri AB. Compliance with the safety instructions, operating manual
and sound common sense will guarantee many years of enjoyment using the product. Kellfri’s equipment
and products are aimed at self-employed farmers, horse enthusiasts and other country-dwellers who have
stringent demands on performance.
PRODUCT INFORMATION
As well as using the hedge trimmer for trimming hedges, you can also use it for clearing saplings from road-
sides and removing protruding branches from trees, for example along field edges where branches can
scratch tractors and equipment.
The hedge trimmer is supplied complete with tank, dual pump and valve block package, plus lever kit with
Teleflex wire for controlling the hedge trimmer from inside the cab.
The 'lever kit' that you lift into the cab is small and flexible, as the valve is on the hedge trimmer and is con-
trolled by means of the Teleflex wire, which is connected to the valve block package from the levers.
The hedge trimmer's hydraulics are operated by means of a pump positioned on the tractor's power take-off.
Working speed is 540 rpm. This means that there is no need for large flows from the tractor, and the hedge
trimmer is suitable for those with a small tractor with a PTO. When using this hedge trimmer, it is important to
remember to adjust the operation to the weight of the tractor. We recommend the use of a tractor weighing
about 1500 kg so that you can operate the crane in its outermost positions.
The crane and the arm on which the cutting unit sits reach 5.5 metres up into the air and 4.8 metres horizon-
tally outwards from the tractor.
Thanks to the hedge trimmer's smart design and ergonomics, it can trim on both sides of the tractor. If you use
it on the tractor's three-point linkage, it has a full movement pattern on the tractor's right-hand side, but more
limited movement on the tractor's left-hand side. The hedge trimmer can also trim below ground level, which
means it works well in ditches and under your electric fence.
TECHNICAL DATA
35-HRT1602
Length
440 mm
Width
1,300 mm
Height
2540 mm
Reach
height: 550 cm/horizontal: 480 cm
Working width
1,600 mm
Cuts branches
up to 35 mm
Weight
223 kg
Power requirement
25-40 hp
Recommended operating speed
3-8 km/h
Speed/min
540 rpm
Volume, oil tank
20 L
