2
INTRODUCTION
Thank you for choosing a product from Kellfri AB. By following general safety information,
operating instructions and common sense, you will have many years of enjoyable use of the
product. Kellfris equipment and products are aimed to be use by active farmers with high
demands on functionality.
PRODUCT INFORMATION
Hedge trimmer with arm for mounting on the tractor’s three-point linkage or for frontloader
with pallet forks
you can use the hedge trimmer for trimming hedges, clearing saplings from roadsides and
removing protruding branches from trees, for example along field edges where branches can
scratch tractors and equipment.
The hedge trimmer is supplied complete with tank, pump and valve block package, plus lever
kit with Teleflex wire for controlling the hedge trimmer from inside the cab.
The ’lever kit’ that you lift into the cab is small and flexible, as the valve is on the hedge trim-
mer and is controlled by Teleflex wire, which is connected to the valve block package from the
levers. The length of the wire is 3 metres, so that it will work on the frontloader or three-point
linkage.
The hedge trimmer’s hydraulics are operated by a pump positioned on the tractor’s power ta-
ke-off. Working speed of the pump is 540 rpm. This means that there is no need for large flows
from the tractor, the hedge trimmer is suitable for those with a small tractor with a PTO. When
using this hedge trimmer, it is important to remember to adjust the operation to the weight of
the tractor. We recommend the use of a
tractor weighing about 1500 kg
so that you can operate
the crane in its outermost positions.
The crane and the arm on which the cutting unit sits reach 5.5 metres up into the air and 4.8
metres horizontally outwards from the tractor.
TECHNICAL DATA
27-HRT160
Length
440 mm
Width
1300 mm
Height
2540 mm
Reach
height: 550 cm / horizontal: 480 cm
Working width
1 600 mm
Weight
223 kg
Power requirements
25-40 hk
Recommended driving speed
3-8 km/h
Recommended rpm
540 rpm
Oil volume (tank)
20 L
IMPORTANT! BEFORE USING THE MACHINE
Check and tighten all bolts, nuts and all connections.
Lubricate all lubrication points and check the oil level in the tank as well as if
there is any leakage in the hydraulic system before operation.
